Cisco 6503 - Catalyst Firewall Security Sys Installation Manual page 275
Installation guide
Hide thumbs
Also See for 6503 - Catalyst Firewall Security Sys:
- White paper (19 pages) ,
- Product bulletin (6 pages) ,
- Supplementary manual (3 pages)
Table of Contents
Advertisement
Chapter 4
Removal and Replacement Procedures
Figure 4-49
Input power
module
Power leads
attached to
terminal block
( - ) Negative
(+) Positive
( - ) Negative
(+) Positive
( - ) Negative
(+) Positive
From the left side of the power supply, connect each of the DC-input wires to the terminal block in
b.
this order (see
Note
Secure outer block cover.
c.
Wire for 6000 W (left side of power supply bay) as follows:
Step 8
From the left side of the power supply, connect the ground wire to the ground (see
a.
OL-5781-08
DC-Input Wire Connections for 4000-W DC-Input Power Supply for Left Side of Power
Bay
block cover
Power
CI SC O SY
ST EM S, IN
C
switch
Captive
installation
screw
Figure 4-47
and
Negative (-)
Positive (+)
When you tighten the terminal nuts, make sure they are snug. Do not over tighten them.
Recommended torque strength is 20 inch-pounds. Over tightening the terminal nuts can
break the terminal block (Maximum torque: 36 inch-pounds).
Removing and Installing the DC-Input Power Supplies
Terminal
1
2
3
IN PU T
OK
4
FA N
OK
OU TP UT
FA IL
( ) Ground
Figure
4-49):
Catalyst 6500 Series Switches Installation Guide
Figure
4-50).
4-69
Advertisement
Table of Contents
Troubleshooting
Related Manuals for Cisco 6503 - Catalyst Firewall Security Sys
Related Products for Cisco 6503 - Catalyst Firewall Security Sys
- Cisco 6503-E - Catalyst Chassis With Supervisor Engine 32 Switch
- Cisco 6504-E - Catalyst Chassis With Supervisor Engine 32 Switch
- Cisco 6506 - Catalyst Chassis Switch
- Cisco 6513 - Catalyst Switch
- Cisco Catalyst 6509
- Cisco Catalyst 6513-E
- Cisco Catalyst 6500-E Series
- Cisco CATALYST 6500 WS-X6066-SLB-S-K9