Table of Contents
Advertisement
4. Lift the cover-release latch. The cover slides to the rear approximately 13 mm
5. Press on the bezel retention tabs at the top edge of the bezel, and pull the top
6. Lift the bezel up to release the two tabs at the bottom edge of the bezel.
Installing a hot-swap power supply
The following notes describe information that you must consider when installing a
hot-swap power supply in the server:
v The server comes with a minimum of one power supply and supports up to two
v The power supplies are numbered from left to right (1 and 2) as viewed from the
v A single 110 V ac power supply can support a maximum configuration of 1
v
Top cover
Bezel
(0.5 inch). Lift the cover off the server.
Attention:
For proper cooling and airflow, replace the top cover before
turning on the server. Operating the server for more than 2 minutes with the top
cover removed might damage server components.
of the bezel slightly away from the server.
power supplies (hot-swappable at 220 V ac only).
rear of the server. Power supplies must be installed in the following sequence:
power supply 1, then power supply 2.
microprocessor, 2 PCI adapters, 3 hard disk drives, and 4 DIMMs. If you exceed
this configuration you must either install a second power supply or use 220 V ac
input.
If you install or remove a power supply, observe the following precautions:
Statement 8:
xS
er
ie r
36
5
Cover release
latch
Chapter 2. Installing options
23
Advertisement
Table of Contents
