Cisco IE-3000-8TC Software Configuration Manual page 132
Software configuration guide
Hide thumbs
Also See for IE-3000-8TC:
- Command reference manual (802 pages) ,
- Administration manual (496 pages) ,
- Message manual (98 pages)
Table of Contents
Advertisement
Configuring Cisco IOS Agents
Command
Step 14
cns config initial {hostname | ip-address}
[port-number] [event] [no-persist] [page page]
[source ip-address] [syntax-check]
Step 15
end
Step 16
show cns config connections
Step 17
show running-config
To disable the CNS Cisco IOS agent, use the no cns config initial {ip-address | hostname} global
configuration command.
This example shows how to configure an initial configuration on a remote switch when the switch
configuration is unknown (the CNS Zero Touch feature).
Switch(config)# cns template connect template-dhcp
Switch(config-tmpl-conn)# cli ip address dhcp
Switch(config-tmpl-conn)# exit
Switch(config)# cns template connect ip-route
Switch(config-tmpl-conn)# cli ip route 0.0.0.0 0.0.0.0 ${next-hop}
Switch(config-tmpl-conn)# exit
Switch(config)# cns connect dhcp
Switch(config-cns-conn)# discover interface gigabitethernet
Switch(config-cns-conn)# template template-dhcp
Switch(config-cns-conn)# template ip-route
Switch(config-cns-conn)# exit
Switch(config)# hostname RemoteSwitch
RemoteSwitch(config)# cns config initial 10.1.1.1 no-persist
Cisco IE 3000 Switch Software Configuration Guide
6-12
Chapter 6
Configuring Cisco IOS Configuration Engine
Purpose
Enable the Cisco IOS agent, and initiate an initial
configuration.
•
For {hostname | ip-address}, enter the hostname or the
IP address of the configuration server.
(Optional) For port-number, enter the port number of
•
the configuration server. The default port number is
80.
(Optional) Enable event for configuration success,
•
failure, or warning messages when the configuration is
finished.
(Optional) Enable no-persist to suppress the
•
automatic writing to NVRAM of the configuration
pulled as a result of entering the cns config initial
global configuration command. If the no-persist
keyword is not entered, using the cns config initial
command causes the resultant configuration to be
automatically written to NVRAM.
(Optional) For page page, enter the web page of the
•
initial configuration. The default is
/Config/config/asp.
•
(Optional) Enter source ip-address to use for source IP
address.
(Optional) Enable syntax-check to check the syntax
•
when this parameter is entered.
Though visible in the command-line help string,
Note
the encrypt, status url, and inventory keywords
are not supported.
Return to privileged EXEC mode.
Verify information about the configuration agent.
Verify your entries.
OL-13018-03
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
