Cisco IE-3000-8TC Software Configuration Manual page 297
Software configuration guide
Hide thumbs
Also See for IE-3000-8TC:
- Command reference manual (802 pages) ,
- Administration manual (496 pages) ,
- Message manual (98 pages)
Table of Contents
Advertisement
Chapter 13
Configuring Interface Characteristics
Beginning in privileged EXEC mode, follow these steps to configure a range of interfaces with the
same parameters:
Command
Step 1
configure terminal
Step 2
interface range {port-range | macro
macro_name}
Step 3
Step 4
end
Step 5
show interfaces [interface-id]
Step 6
copy running-config startup-config
When using the interface range global configuration command, note these guidelines:
•
•
•
OL-13018-03
Valid entries for port-range:
vlan vlan-ID, where the VLAN ID is 1 to 4094
–
Although the command-line interface shows options to set multiple VLANs, these
Note
options are not supported.
fastethernet stack member/module/{first port} - {last port}, where the module is always 0
–
gigabitethernet module/{first port} - {last port}
–
port-channel port-channel-number - port-channel-number, where the port-channel-number
–
is 1 to 6
When you use the interface range command with port channels, the first and last
Note
port-channel number must be active port channels.
You must add a space between the first interface number and the hyphen when using the
interface range command. For example, the command interface range gigabitethernet1/1 - 2 is a
valid range; the command interface range gigabitethernet1/1-2 is not a valid range.
The interface range command only works with VLAN interfaces that have been configured with
the interface vlan command. The show running-config privileged EXEC command displays the
configured VLAN interfaces. VLAN interfaces not displayed by the show running-config
command cannot be used with the interface range command.
Purpose
Enter global configuration mode.
Specify the range of interfaces (VLANs or physical ports) to be
configured, and enter interface-range configuration mode.
You can use the interface range command to configure up to five
•
port ranges or a previously defined macro.
The macro variable is explained in the
•
Interface Range Macros" section on page
In a comma-separated port-range, you must enter the interface
•
type for each entry and enter spaces before and after the comma.
In a hyphen-separated port-range, you do not need to re-enter the
•
interface type, but you must enter a space before the hyphen.
Use the normal configuration commands to apply the configuration
parameters to all interfaces in the range. Each command is executed
as it is entered.
Return to privileged EXEC mode.
Verify the configuration of the interfaces in the range.
(Optional) Save your entries in the configuration file.
Cisco IE 3000 Switch Software Configuration Guide
Using Interface Configuration Mode
"Configuring and Using
13-8.
13-7
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
