Monitoring Flex Links And The Mac Address-Table Move Update - Cisco IE-3000-8TC Software Configuration Manual

Software configuration guide

Hide thumbs Also See for IE-3000-8TC:

Table of Contents

Monitoring Flex Links and the MAC Address-Table Move Update

show mac address-table move update

copy running-config startup config

To disable the MAC address-table move update feature, use the no mac address-table move update

receive configuration command. To display the MAC address-table move update information, use the

show mac address-table move update privileged EXEC command.

This example shows how to configure a switch to get and process MAC address-table move update

Switch# configure terminal

Switch(conf)# mac address-table move update receive

Switch(conf)# end

Monitoring Flex Links and the MAC Address-Table

MAC address-table move update information.

Flex Links and MAC Address-Table Move Update Monitoring Commands

show interfaces [interface-id] switchport

show mac address-table move update

Cisco IE 3000 Switch Software Configuration Guide

shows the privileged EXEC commands for monitoring the Flex Links configuration and the

Displays the Flex Link backup interface configured for an interface or all the

configured Flex Links and the state of each active and backup interface (up

or standby mode). When VLAN load balancing is enabled, the output

displays the preferred VLANS on Active and Backup interfaces.

Displays the MAC address-table move update information on the switch.

Configuring Flex Links and the MAC Address-Table Move Update Feature

Verify the configuration.

(Optional) Save your entries in the switch startup

configuration file.

Show Quick Links

Table of Contents