Creating A Numbered Extended Acl - Cisco IE-3000-8TC Software Configuration Manual
Software configuration guide
Hide thumbs
Also See for IE-3000-8TC:
- Command reference manual (802 pages) ,
- Administration manual (496 pages) ,
- Message manual (98 pages)
Table of Contents
Advertisement
Configuring IPv4 ACLs
The switch always rewrites the order of standard access lists so that entries with host matches and entries
with matches having a don't care mask of 0.0.0.0 are moved to the top of the list, above any entries with
non-zero don't care masks. Therefore, in show command output and in the configuration file, the ACEs
do not necessarily appear in the order in which they were entered.
After creating a numbered standard IPv4 ACL, you can apply it to terminal lines (see the
IPv4 ACL to a Terminal Line" section on page
to an Interface" section on page
Creating a Numbered Extended ACL
Although standard ACLs use only source addresses for matching, you can use extended ACL source and
destination addresses for matching operations and optional protocol type information for finer
granularity of control. When you are creating ACEs in numbered extended access lists, remember that
after you create the ACL, any additions are placed at the end of the list. You cannot reorder the list or
selectively add or remove ACEs from a numbered list.
Some protocols also have specific parameters and keywords that apply to that protocol.
These IP protocols are supported (protocol keywords are in parentheses in bold):
Authentication Header Protocol (ahp), Enhanced Interior Gateway Routing Protocol (eigrp),
Encapsulation Security Payload (esp), generic routing encapsulation (gre), Internet Control Message
Protocol (icmp), Internet Group Management Protocol (igmp), any Interior Protocol (ip), IP in IP
tunneling (ipinip), KA9Q NOS-compatible IP over IP tunneling (nos), Open Shortest Path First routing
(ospf), Payload Compression Protocol (pcp), Protocol Independent Multicast (pim), Transmission
Control Protocol (tcp), or User Datagram Protocol (udp).
Note
For more details on the specific keywords for each protocol, see these command references:
•
•
•
These documents are available from the Cisco.com page under Documentation > Cisco IOS Software
> 12.2 Mainline > Command References.
The switch does not support dynamic or reflexive access lists. It also does not support filtering based on
Note
the type of service (ToS) minimize-monetary-cost bit.
Supported parameters can be grouped into these categories: TCP, UDP, ICMP, IGMP, or other IP.
Cisco IE 3000 Switch Software Configuration Guide
34-8
ICMP echo-reply cannot be filtered. All other ICMP codes or types can be filtered.
Cisco IOS IP Command Reference, Volume 1 of 3: Addressing and Services, Release 12.2
Cisco IOS IP Command Reference, Volume 2 of 3: Routing Protocols, Release 12.2
Cisco IOS IP Command Reference, Volume 3 of 3: Multicast, Release 12.2
34-16) and to interfaces (see the
34-16).
Chapter 34
Configuring Network Security with ACLs
"Applying an IPv4 ACL
"Applying an
OL-13018-03
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
