Classifying, Policing, And Marking Traffic On Physical Ports By Using Policy Maps - Cisco IE-3000-8TC Software Configuration Manual
Software configuration guide
Hide thumbs
Also See for IE-3000-8TC:
- Command reference manual (802 pages) ,
- Administration manual (496 pages) ,
- Message manual (98 pages)
Table of Contents
Advertisement
Configuring Standard QoS
This example shows how to create a class map called class2, which matches incoming traffic with DSCP
values of 10, 11, and 12.
Switch(config)# class-map class2
Switch(config-cmap)# match ip dscp 10 11 12
Switch(config-cmap)# end
Switch#
This example shows how to create a class map called class3, which matches incoming traffic with
IP-precedence values of 5, 6, and 7:
Switch(config)# class-map class3
Switch(config-cmap)# match ip precedence 5 6 7
Switch(config-cmap)# end
Switch#
Classifying, Policing, and Marking Traffic on Physical Ports by Using Policy Maps
You can configure a policy map on a physical port that specifies which traffic class to act on. Actions
can include trusting the CoS, DSCP, or IP precedence values in the traffic class; setting a specific DSCP
or IP precedence value in the traffic class; and specifying the traffic bandwidth limitations for each
matched traffic class (policer) and the action to take when the traffic is out of profile (marking).
A policy map also has these characteristics:
•
•
•
Follow these guidelines when configuring policy maps on physical ports:
•
•
•
•
•
Cisco IE 3000 Switch Software Configuration Guide
36-44
A policy map can contain multiple class statements, each with different match criteria and policers.
A separate policy-map class can exist for each type of traffic received through a port.
A policy-map trust state and a port trust state are mutually exclusive, and whichever is configured
last takes affect.
You can attach only one policy map per ingress port.
If you configure the IP-precedence-to-DSCP map by using the mls qos map ip-prec-dscp
dscp1...dscp8 global configuration command, the settings only affect packets on ingress interfaces
that are configured to trust the IP precedence value. In a policy map, if you set the packet IP
precedence value to a new value by using the set ip precedence new-precedence policy-map class
configuration command, the egress DSCP value is not affected by the IP-precedence-to-DSCP map.
If you want the egress DSCP value to be different than the ingress value, use the set dscp new-dscp
policy-map class configuration command.
If you enter or have used the set ip dscp command, the switch changes this command to set dscp in
its configuration.
You can use the set ip precedence or the set precedence policy-map class configuration command
to change the packet IP precedence value. This setting appears as set ip precedence in the switch
configuration.
A policy-map and a port trust state can both run on a physical interface. The policy-map is applied
before the port trust state.
Chapter 36
Configuring QoS
OL-13018-03
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
