Appendix; Unsupported Commands In Cisco Ios Release 12.2(50)Se; Access Control Lists; Unsupported Privileged Exec Commands - Cisco IE-3000-8TC Software Configuration Manual
Software configuration guide
Hide thumbs
Also See for IE-3000-8TC:
- Command reference manual (802 pages) ,
- Administration manual (496 pages) ,
- Message manual (98 pages)
Table of Contents
Advertisement
Unsupported Commands in
Cisco IOS Release 12.2(50)SE
This appendix lists some of the command-line interface (CLI) commands that appear when you enter the
question mark (?) at the IE 3000 switch prompt but are not supported in this release, either because they
are not tested or because of switch hardware limitations. This is not a complete list. These unsupported
commands are listed by software feature and command mode:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Access Control Lists
Unsupported Privileged EXEC Commands
access-enable [host] [timeout minutes]
access-template [access-list-number | name] [dynamic-name] [source] [destination] [timeout minutes]
clear access-template [access-list-number | name] [dynamic-name] [source] [destination].
show access-lists rate-limit [destination]
OL-13018-03
Access Control Lists, page C-1
Boot Loader Commands, page C-2
Debug Commands, page C-2
|IGMP Snooping Commands, page C-2
Interface Commands, page C-3
MAC Address Commands, page C-3
Miscellaneous, page C-4
Network Address Translation (NAT) Commands, page C-4
QoS, page C-4
SNMP, page C-5
SNMPv3, page C-5
Spanning Tree, page C-6
VLAN, page C-6
VTP, page C-6
A P P E N D I X
Cisco IE 3000 Switch Software Configuration Guide
C
C-1
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
