Classification Based On Qos Acls; Classification Based On Class Maps And Policy Maps - Cisco 3020 - Catalyst Blade Switch Configuration Manual
Cisco catalyst blade switch 3020 for hp software configuration guide, rel. 12.2(25)sef1
Hide thumbs
Also See for 3020 - Cisco Catalyst Blade Switch:
- Command reference manual (744 pages) ,
- Release note (54 pages) ,
- Getting started manual (37 pages)
Table of Contents
Advertisement
Chapter 27
Configuring QoS
Classification Based on QoS ACLs
You can use IP standard, IP extended, or Layer 2 MAC ACLs to define a group of packets with the same
characteristics (class). In the QoS context, the permit and deny actions in the access control entries
(ACEs) have different meanings than with security ACLs:
•
•
•
•
When creating an access list, remember that, by default, the end of the access list contains an implicit
Note
deny statement for everything if it did not find a match before reaching the end.
After a traffic class has been defined with the ACL, you can attach a policy to it. A policy might contain
multiple classes with actions specified for each one of them. A policy might include commands to
classify the class as a particular aggregate (for example, assign a DSCP) or rate-limit the class. This
policy is then attached to a particular port on which it becomes effective.
You implement IP ACLs to classify IP traffic by using the access-list global configuration command;
you implement Layer 2 MAC ACLs to classify non-IP traffic by using the mac access-list extended
global configuration command. For configuration information, see the
section on page
Classification Based on Class Maps and Policy Maps
A class map is a mechanism that you use to name a specific traffic flow (or class) and to isolate it from
all other traffic. The class map defines the criteria used to match against a specific traffic flow to further
classify it. The criteria can include matching the access group defined by the ACL or matching a specific
list of DSCP or IP precedence values. If you have more than one type of traffic that you want to classify,
you can create another class map and use a different name. After a packet is matched against the
class-map criteria, you further classify it through the use of a policy map.
A policy map specifies which traffic class to act on. Actions can include trusting the CoS, DSCP, or IP
precedence values in the traffic class; setting a specific DSCP or IP precedence value in the traffic class;
or specifying the traffic bandwidth limitations and the action to take when the traffic is out of profile.
Before a policy map can be effective, you must attach it to a port.
You create a class map by using the class-map global configuration command or the class policy-map
configuration command. You should use the class-map command when the map is shared among many
ports. When you enter the class-map command, the switch enters the class-map configuration mode. In
this mode, you define the match criterion for the traffic by using the match class-map configuration
command.
You create and name a policy map by using the policy-map global configuration command. When you
enter this command, the switch enters the policy-map configuration mode. In this mode, you specify the
actions to take on a specific traffic class by using the class, trust, or set policy-map configuration and
policy-map class configuration commands.
OL-8915-01
If a match with a permit action is encountered (first-match principle), the specified QoS-related
action is taken.
If a match with a deny action is encountered, the ACL being processed is skipped, and the next ACL
is processed.
If no match with a permit action is encountered and all the ACEs have been examined, no QoS
processing occurs on the packet, and the switch offers best-effort service to the packet.
If multiple ACLs are configured on a port, the lookup stops after the packet matches the first ACL
with a permit action, and QoS processing begins.
27-41.
Cisco Catalyst Blade Switch 3020 for HP Software Configuration Guide
Understanding QoS
"Configuring a QoS Policy"
27-7
Advertisement
Table of Contents
Troubleshooting
