Cisco 2950G 24 - Catalyst Switch Software Configuration Manual page 123
Desktop switch
Hide thumbs
Also See for 2950G 24 - Catalyst Switch:
- Migration manual (25 pages) ,
- Datasheet (19 pages) ,
- Product support bulletin (5 pages)
Table of Contents
Advertisement
Chapter 5
Configuring IE2100 CNS Agents
Command
Step 8
cns config initial {ip-address | hostname} [port-number]
[event] [no-persist] [page page] [source ip-address]
[syntax-check]
Step 9
end
Step 10
show cns config connections
Step 11
show running-config
To disable the CNS configuration agent, use the no cns config initial {ip-address | hostname} global
configuration command.
This example shows how to configure an initial configuration on a remote switch. The switch host name
is the unique ID. The CNS Configuration Registrar IP address is 172.28.129.22.
Switch(config)# cns config connect-intf serial ping-interval 1 retries 1
Switch(config-cns-conn-if)# config-cli ip address negotiated
Switch(config-cns-conn-if)# config-cli encapsulation ppp
Switch(config-cns-conn-if)# config-cli ip directed-broadcast
Switch(config-cns-conn-if)# config-cli no keepalive
Switch(config-cns-conn-if)# config-cli no shutdown
Switch(config-cns-conn-if)# exit
Switch(config)# hostname RemoteSwitch
RemoteSwitch(config)# ip route 10.1.1.1 255.255.255.255 11.11.11.1
RemoteSwitch(config)# cns id Ethernet 0 ipaddress
RemoteSwitch(config)# cns config initial 10.1.1.1 no-persist
78-14982-01
Purpose
Enable the configuration agent, and initiate an initial
configuration.
•
For {ip-address | hostname}, enter the
IP address or the host name of the configuration
server.
(Optional) For port-number, enter the port
•
number of the configuration server. The default
port number is 80.
(Optional) Enable event for configuration
•
success, failure, or warning messages when the
configuration is finished.
•
(Optional) Enable no-persist to suppress the
automatic writing to NVRAM of the
configuration pulled as a result of entering the
cns config initial global configuration
command. If the no-persist keyword is not
entered, using the cns config initial command
causes the resultant configuration to be
automatically written to NVRAM.
(Optional) For page page, enter the web page of
•
the initial configuration. The default is
/Config/config/asp.
•
(Optional) Enter source ip-address to use for
source IP address.
•
(Optional) Enable syntax-check to check the
syntax when this parameter is entered.
Note
Though visible in the command-line help
string, the encrypt keyword is not supported.
Return to privileged EXEC mode.
Verify information about the configuration agent.
Verify your entries.
Catalyst 2950 Desktop Switch Software Configuration Guide
Configuring CNS Embedded Agents
5-11
- Quick Links:
- Default Ntp Configuration
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
