Chapter 14 Configuring Vlan; Supported Vlans - Cisco 2950G 24 - Catalyst Switch Software Configuration Manual
Desktop switch
Hide thumbs
Also See for 2950G 24 - Catalyst Switch:
- Migration manual (25 pages) ,
- Datasheet (19 pages) ,
- Product support bulletin (5 pages)
Table of Contents
Advertisement
Understanding VLANs
For a Catalyst 2950 LRE Switch, the maximum supported number of VLANs is 250, the maximum
number of STP instances is 64, and trunking is supported. The Catalyst 2950 LRE also supports 4094
VLAN IDs. The 2950 LRE software image is based on the EI software and supports the same number of
VLANs, VLAN IDs, and STP instances as the EI software image.
Figure 14-1
Figure 14-1 VLANs as Logically Defined Networks
Cisco router
VLANs are often associated with IP subnetworks. For example, all the end stations in a particular IP
subnet belong to the same VLAN. Interface VLAN membership on the switch is assigned manually on
an interface-by-interface basis. When you assign switch interfaces to VLANs by using this method, it is
known as interface-based, or static, VLAN membership.
Supported VLANs
Catalyst 2950 switches that run the standard software image (SI) support 64 VLANs; switches that run
the enhanced software image (EI) support 250 VLANs. Refer to the release notes for the list of switches
that support each image. VLANs are identified with a number from 1 to 4094 when the EI is installed
and 1 to 1005 when the SI is installed. VLAN IDs 1002 through 1005 are reserved for Token Ring and
FDDI VLANs. VTP only learns normal-range VLANs, with VLAN IDs 1 to 1005; VLAN IDs greater
than 1005 are extended-range VLANs and are not stored in the VLAN database. The switch must be in
VTP transparent mode when you create VLAN IDs from 1006 to 4094.
The switch supports per-VLAN spanning tree (PVST) with a maximum of 64 spanning-tree instances.
One spanning-tree instance is allowed per VLAN. See the
Guidelines" section on page 14-5
the number of VLANs. The switch supports IEEE 802.1Q trunking for sending VLAN traffic over
Ethernet ports.
Catalyst 2950 Desktop Switch Software Configuration Guide
14-2
shows an example of VLANs segmented into logically defined networks.
Fast
Ethernet
Engineering
Marketing
VLAN
VLAN
"Normal-Range VLAN Configuration
for more information about the number of spanning-tree instances and
Chapter 14
Configuring VLANs
Accounting
VLAN
Floor 3
Floor 2
Floor 1
78-14982-01
- Quick Links:
- Default Ntp Configuration
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
