Hardware Problems - HP Brio ba300 Troubleshooting Manual
Hp brio ba300, troubleshooting guide
Hide thumbs
Also See for Brio ba300:
- Technical reference manual (38 pages) ,
- Quick user manual (33 pages) ,
- Upgrade manual (24 pages)
Table of Contents
Advertisement
If You Have a Problem
Hardware Problems
This section provides information on how to solve problems with your keyboard, monitor, drives or
printer.
WARNING
Be sure to disconnect the power cord and any telecommunication cables from your computer before you remove the cover
to check the cable connections or jumper settings.
To avoid electrical shock and harm to your eyes by laser light, do not open the laser module of the CD-ROM. The laser
module should only be serviced by service personnel. Do not attempt to make any adjustment to the laser unit. Refer to
the label on the CD-ROM for power requirements and wavelength. This PC is a class 1 laser product.
The Keyboard Doesn't Work Properly
Have you checked that...
The keyboard cable is correctly connected
The keyboard is clean and no keys are stuck
down
The keyboard itself is not defective
The keyboard settings are not causing a problem
You are using the latest BIOS for your PC
You didn't spill anything on the keyboard
There's a Problem with the Hard Disk
Have you checked that...
The disk is not damaged in some way
You have not disabled the option to boot your PC
from the hard drive in the B B B B o o o o o o o o t t t t menu of the
Setup program
The hard disk drive has been detected
The Local Bus IDE Adapter item is correctly
configured in the Setup program
Advanced Troubleshooting
All the hard drive's internal connections and both
ends of the status panel are correctly connected
The jumpers on the hard drive are set correctly
12
How
Ö
Plug the cable into the correct connector on the back of the PC. Color coding
is used for easy matching.
Ö
Check all keys are at the same height, and none are stuck
Ö
Either replace the keyboard by a known working unit or try the keyboard
with another PC
Ö
Select Settings Ö Ö Ö Ö Control Panel Ö Ö Ö Ö Keyboard from the Start menu
to view your keyboard settings
Ö
Download the latest BIOS and instructions for its installation from HP's Web
at:
www.hp.com/go/briosupport
Ö
Clean the keyboard with a damp cloth. Do not wet it.
How
Ö
Run ScanDisk and Disk Defragmenter to see if they detect a problem with
the hard disk drive. To access these utilities, select Programs Ö Ö Ö Ö
Accessories Ö Ö Ö Ö System Tools from the Start menu.
Ö
Enter the Setup program by pressing F2 at startup, then go to the Boot
menu.
Ö
Enter the Setup program by pressing F2 at startup, then go to the Main
menu. You should see a hard disk drive declared in the Primary Master
field.
Ö
Enter the Setup program by pressing F2 at startup, then go to the
Advanced menu. Make sure you have selected both in the Local Bus
IDE Adapter field.
Ö
Check that the drive's power and data cables are correctly connected at
both ends (hard drive and system board). Refer to the Brio BA300 Upgrade
Guide (details on page 5).
Ö
Check that the jumpers on the hard drive are in CS (cable select) mode
Advertisement
Table of Contents
Troubleshooting
