Other Configuration Problems - HP Vectra XE310 Troubleshooting Manual
Hp vectra xe310, troubleshooting guide
Hide thumbs
Also See for Vectra XE310:
- Technical reference manual (42 pages) ,
- Upgrade manual (28 pages) ,
- Service handbook chapter (16 pages)
Table of Contents
Advertisement
Serial or Parallel Port Test Error
Have you checked that...
The port is correctly configured in the PC's
Setup program
You have not connected a device incorrectly or
forgotten to switch it on
You have installed the correct device drivers
There is not a hardware problem
You are using the latest BIOS for your PC
If the problem persists, contact your authorized support provider
Other Configuration Problems
If the POST produces an error not covered in this section...
Have you checked that...
The Setup program settings are correct
You are using the latest BIOS for your PC
If the problem persists, contact your authorized support provider
How
1
Switch the PC OFF then ON.
2
Press F8 just after the computer powers-on, then select Enter Setup.
3
Check the port is enabled and the correct setting is selected under I/O
Device Configuration in the Advanced menu.
1
Switch off the PC.
2
Plug the cables into the correct connectors on the back of the PC.
3
Switch on the PC and the external devices.
Refer to the documentation for your serial or parallel device.
Run e-Diagtools. Refer to page 28.
Download the latest BIOS and instructions for its installation from HP's Web
at:
www.hp.com/go/vectrasupport
How
1
Turn on or restart the PC.
2
Press F8 just after the computer powers-on, then select Enter Setup.
Download the latest BIOS and instructions for its installation from HP's Web
at:
www.hp.com/go/vectrasupport
If You Have a Problem
25 Troubleshooting Guide
Advertisement
Table of Contents
