Enabling Hsrp - Cisco 3845 - Security Bundle Router Software Manual
Software configuration guide
Hide thumbs
Also See for 3845 - Security Bundle Router:
- Manual (94 pages) ,
- Quick start manual (38 pages) ,
- Hardware installation manual (418 pages)
Table of Contents
Advertisement
Configuring HSRP
•
•
•
Enabling HSRP
The standby ip interface configuration command activates HSRP on the configured interface. If an IP
address is specified, that address is used as the designated address for the Hot Standby group. If no IP
address is specified, the address is learned through the standby function. You must configure at least one
Layer 3 port on the LAN with the designated address. Configuring an IP address always overrides
another designated address currently in use.
When the standby ip command is enabled on an interface and proxy ARP is enabled, if the interface's
Hot Standby state is active, proxy ARP requests are answered using the Hot Standby group MAC
address. If the interface is in a different state, proxy ARP responses are suppressed.
Beginning in privileged EXEC mode, follow these steps to create or enable HSRP on a Layer 3 interface:
Command
Step 1
configure terminal
Step 2
interface interface-id
Step 3
no switchport
Step 4
standby version {1 | 2}
Step 5
standby [group-number] ip [ip-address
[secondary]]
Cisco ME 3800X and 3600X Switch Software Configuration Guide
30-6
HSRPv2 and HSRPv1 can be configured on the same switch if HSRPv2 is configured on different
interfaces than those on which HSRPv1 is configured.
The version of an HSRP group can be changed from HSRPv2 to HSRPv1 only if the group number
is less than 256.
If you change the HSRP version on an interface, each HSRP group resets because it now has a new
virtual MAC address.
Purpose
Enter global configuration mode.
Enter interface configuration mode, and enter the Layer 3 interface on
which you want to enable HSRP.
If necessary, disable Layer 2 switching on the port to enable the Layer 3
interface.
(Optional) Configure the HSRP version on the interface.
If you do not enter this command or do not specify a keyword, the
interface runs the default HSRP version, HSRP v1.
Create (or enable) the HSRP group using its number and virtual IP
address.
1— Select HSRPv1.
•
2— Select HSRPv2.
•
•
(Optional) group-number—The group number on the interface for
which HSRP is being enabled. The range is 0 to 255; the default is 0.
If there is only one HSRP group, you do not need to enter a group
number.
•
(Optional on all but one interface) ip-address—The virtual IP address
of the hot standby router interface. You must enter the virtual IP
address for at least one of the interfaces; it can be learned on the other
interfaces.
•
(Optional) secondary—The IP address is a secondary hot standby
router interface. If neither router is designated as a secondary or
standby router and no priorities are set, the primary IP addresses are
compared and the higher IP address is the active router, with the next
highest as the standby router.
Chapter 30
Configuring HSRP
OL-23400-01
- Quick Links:
- Performance Features
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
