Cisco 3845 - Security Bundle Router Software Manual page 763
Software configuration guide
Hide thumbs
Also See for 3845 - Security Bundle Router:
- Manual (94 pages) ,
- Quick start manual (38 pages) ,
- Hardware installation manual (418 pages)
Table of Contents
Advertisement
Chapter 33
Configuring IP Multicast Routing
Defining the IP Multicast Boundary
You define a multicast boundary to prevent Auto-RP messages from entering the PIM domain. You
create an access list to deny packets destined for 224.0.1.39 and 224.0.1.40, which carry Auto-RP
information.
Beginning in privileged EXEC mode, follow these steps to define a multicast boundary. This procedure
is optional.
Command
Step 1
configure terminal
Step 2
access-list access-list-number deny
source [source-wildcard]
Step 3
interface interface-id
Step 4
ip multicast boundary
access-list-number
Step 5
end
Step 6
show running-config
Step 7
copy running-config startup-config
To remove the boundary, use the no ip multicast boundary interface configuration command.
This example shows a portion of an IP multicast boundary configuration that denies Auto-RP
information:
Switch(config)# access-list 1 deny 224.0.1.39
Switch(config)# access-list 1 deny 224.0.1.40
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# ip multicast boundary 1
Configuring Candidate BSRs
You can configure one or more candidate BSRs. The devices serving as candidate BSRs should have
good connectivity to other devices and be in the backbone portion of the network.
OL-23400-01
Purpose
Enter global configuration mode.
Create a standard access list, repeating the command as many times as
necessary.
•
For access-list-number, the range is 1 to 99.
The deny keyword denies access if the conditions are matched.
•
For source, enter multicast addresses 224.0.1.39 and 224.0.1.40,
•
which carry Auto-RP information.
•
(Optional) For source-wildcard, enter the wildcard bits in dotted
decimal notation to be applied to the source. Place ones in the bit
positions that you want to ignore.
Recall that the access list is always terminated by an implicit deny
statement for everything.
Specify the interface to be configured, and enter interface configuration
mode.
Configure the boundary, specifying the access list you created in Step 2.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Cisco ME 3800X and 3600X Switch Software Configuration Guide
Configuring IP Multicast Routing
33-29
- Quick Links:
- Performance Features
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
