Cisco 7604 Configuration Manual page 586
Ios software configuration guide
Hide thumbs
Also See for 7604:
- Configuration manual (742 pages) ,
- Installation manual (324 pages) ,
- User manual (98 pages)
Table of Contents
Advertisement
Configuring DAI
Configuring the DAI Logging System Messages
To configure the DAI logging system messages, perform this task:
Command
Step 1
Router# configure terminal
Step 2
Router(config)# ip arp inspection log-buffer logs
number_of_messages interval length_in_seconds
Router(config)# no ip arp inspection log-buffer
logs
Step 3
Router(config)# do show ip arp inspection log
When configuring the DAI logging system messages, note the following information:
•
•
•
This example shows how to configure DAI logging to send 12 messages every 2 seconds:
Router# configure terminal
Enter configuration commands, one per line.
Router(config)# ip arp inspection log-buffer logs 12 interval 2
Router(config)# do show ip arp inspection log | include Syslog
Syslog rate : 12 entries per 2 seconds.
This example shows how to configure DAI logging to send 20 messages every 60 seconds.
Router# configure terminal
Enter configuration commands, one per line.
Router(config)# ip arp inspection log-buffer logs 20 interval 60
Router(config)# do show ip arp inspection log | include Syslog
Syslog rate : 20 entries per 60 seconds.
Configuring DAI Log Filtering
To configure DAI log filtering, perform this task:
Command
Step 1
Router# configure terminal
Step 2
Router(config)# ip arp inspection vlan vlan_range
logging {acl-match {matchlog | none} |
dhcp-bindings {all | none | permit}}
Step 3
Router(config)# do show running-config | include
ip arp inspection vlan vlan_range
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
38-14
For logs number_of_messages (default is 5), the range is 0 to 1024. A 0 value means that the entry
is placed in the log buffer, but a system message is not generated.
For interval length_in_seconds (default is 1), the range is 0 to 86400 seconds (1 day). A 0 value
means that a system message is immediately generated (and the log buffer is always empty). An
interval setting of 0 overrides a log setting of 0.
System messages are sent at the rate of number_of_messages per length_in_seconds.
Chapter 38
Purpose
Enters global configuration mode.
Configures the DAI logging buffer.
Reverts to the default system message configuration.
Verifies the configuration.
End with CNTL/Z.
End with CNTL/Z.
Purpose
Enters global configuration mode.
Configures log filtering for each VLAN.
Verifies the configuration.
Configuring Dynamic ARP Inspection
OL-4266-08
- Quick Links:
- Supported Hardware and Software
Hide quick links:
Advertisement
Chapters
Table of Contents
