Using The No And Default Forms Of Commands - Cisco ASR1002 - ASR 1002 Router Software Configuration Manual
Asr 1000 series aggregation services routers
Hide thumbs
Also See for ASR1002 - ASR 1002 Router:
- Quick start manual (47 pages) ,
- Installation manual (46 pages) ,
- Configuration manual (34 pages)
Table of Contents
Advertisement
Using Cisco IOS XE Software
Table 9
Finding Command Options (continued)
Command
Router(config-if)# ip address ?
A.B.C.D
IP address
negotiated
IP Address negotiated over PPP
Router(config-if)# ip address
Router(config-if)# ip address 172.16.0.1 ?
A.B.C.D
IP subnet mask
Router(config-if)# ip address 172.16.0.1
Router(config-if)# ip address 172.16.0.1 255.255.255.0 ?
secondary
Make this IP address a secondary
address
<cr>
Router(config-if)# ip address 172.16.0.1 255.255.255.0
Router(config-if)# ip address 172.16.0.1 255.255.255.0
Router(config-if)#
Using the no and default Forms of Commands
Almost every configuration command has a no form. In general, use the no form to disable a function.
Use the command without the no keyword to re-enable a disabled function or to enable a function that
is disabled by default. For example, IP routing is enabled by default. To disable IP routing, use the no ip
routing command; to re-enable IP routing, use the ip routing command. The Cisco IOS software
command reference publications provide the complete syntax for the configuration commands and
describe what the no form of a command does.
Many CLI commands also have a default form. By issuing the command default command-name, you
can configure the command to its default setting. The Cisco IOS software command reference
publications describe the function of the default form of the command when the default form performs
a different function than the plain and no forms of the command. To see what default commands are
available on your system, enter default ? in the appropriate command mode.
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
Using the no and default Forms of Commands
Comment
Enter the command that you want to configure for
the interface. This example uses the ip address
command.
Enter ? to display what you must enter next on the
command line. In this example, you must enter an IP
address or the negotiated keyword.
A carriage return (<cr>) is not displayed; therefore,
you must enter additional keywords or arguments to
complete the command.
Enter the keyword or argument that you want to use.
This example uses the 172.16.0.1 IP address.
Enter ? to display what you must enter next on the
command line. In this example, you must enter an IP
subnet mask.
A <cr> is not displayed; therefore, you must enter
additional keywords or arguments to complete the
command.
Enter the IP subnet mask. This example uses the
255.255.255.0 IP subnet mask.
Enter ? to display what you must enter next on the
command line. In this example, you can enter the
secondary keyword, or you can press Enter.
A <cr> is displayed; you can press Enter to
complete the command, or you can enter another
keyword.
In this example, Enter is pressed to complete the
command.
11
Advertisement
Table of Contents
Troubleshooting
