Viewing The Configuration - Cisco MWR 1941-DC - 1941 Mobile Wireless Router Software Configuration Manual
Mobile wireless edge router
Hide thumbs
Also See for MWR 1941-DC - 1941 Mobile Wireless Router:
- Hardware installation manual (106 pages) ,
- User manual (40 pages) ,
- Rack mounting instructions (13 pages)
Table of Contents
Advertisement
Chapter 3
First-Time Configuration
DRAM configuration is 64 bits wide with parity disabled.
55K bytes of non-volatile configuration memory.
39168K bytes of ATA Slot0 CompactFlash (Read/Write)
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
When the following message appears, enter yes to begin the initial configuration dialog:
Step 2
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system
Would you like to enter basic management setup? [yes/no]:y
Configuring global parameters:
Enter a host name for the router (this example uses 1941-1):
Step 3
Configuring global parameters:
Enter host name [Router]: 1941-1
Step 4
Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when
viewing the configuration:
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret: xxxx
Enter an enable password that is different from the enable secret password. This password is not
Step 5
encrypted (less secure) and can be seen when viewing the configuration:
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: guessme
Enter the virtual terminal password, which prevents unauthenticated access to the router through ports
Step 6
other than the console port:
The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password: guessagain
Respond to the following prompts as appropriate for your network:
Step 7
Configure SNMP Network Management? [yes]:
Community string [public]:
The summary of interfaces is displayed. This list varies depending on the network modules, if any,
Step 8
installed in your router.
Current interface summary
Controller Timeslots D-Channel Configurable modes Status
T1 0/0
T1 0/1
T1 0/2
T1 0/3
Interface
OL-11503-01
24
23
pri/channelized
24
23
pri/channelized
24
23
pri/channelized
24
23
pri/channelized
IP-Address
Cisco MWR 1941-DC Mobile Wireless Edge Router Software Configuration Guide
Administratively up
Administratively up
Administratively up
Administratively up
OK? Method Status
Configuring Global Parameters
Protocol
3-5
Advertisement
Table of Contents
