Cisco SFE2000P Installation And Configuration Manual page 88
Configuration guide
Hide thumbs
Also See for SFE2000P:
- Datasheet (7 pages) ,
- Configuration manual (406 pages) ,
- Reference manual (286 pages)
Table of Contents
Advertisement
Initial System Configuration
You are asked whether to apply and save the configuration.
Step 3
Apply and Save this configuration? [yes/no]:
To apply and save the configuration, type yand press Enter.
•
•
To abort the setup procedure without applying or saving the configuration (recommended if there
are errors), type nand press Enter.
Setup procedure aborted, no configuration changes made.
If the setup is aborted, the dialog is ended.
If there are no errors, the system requests confirmation of either a yes or no answer, in order to prevent
Step 4
mistakes.
Type the appropriate answer (y or n) and press Enter.
The running configuration would be overwritten by the changes you have just entered, are
you sure? [yes/no]:
The selected action is carried out by the system.
•
If the apply and save action is not confirmed ( no ), the setup is aborted.
Setup procedure aborted, no configuration changes made.
If the apply and save action is confirmed ( yes ), the configuration is applied and saved.
•
The new running configuration will be saved to the startup configuration.
If the configuration was applied and saved, you may also save it to a file at a remote station.
Step 5
Do you want to save a copy of the startup configuration file in a remote station? [no]:
To save the configuration to a remote station, type yand press Enter.
The system will ask for FTP path:
Enter a full FTP path of the remote destination:
The system informs you that the configuration is complete.
Step 6
Committing configuration...
Configuration completed successfully.
Saving configuration...
Writing general configuration file to temporary location...
Backing-up general configuration file...
Copy temporary file to final location...
Done!
EXAMPLE 1:
Following is an example of a configuration that the user aborted due to errors detected in the
configuration.
Note that no confirmation is requested for the decision to abort the setup. Had there been no errors,
confirmation would have been requested before aborting.
Data collection for the system configuration is completed.
Would you like to view the new configuration before it is applied? [yes/no]: nFound errors
in the new configuration, would you like to view them? [yes]: yThe following errors were
found:
Warning - RDR formatter destination 10.1.1.1 is not allowed in the IP access-class.
Warning - default Gateway 10.1.1.1 is not allowed in the IP access-class.
Warning - IP Access list (1) conflicts with Telnet Access list (2) as follows:
Access list 2 permits all addresses while Access list 1 denies it.
Apply and Save this configuration? [yes/no]: nSetup procedure aborted, no configuration
changes made.
EXAMPLE 2:
Following is an example of a configuration that was applied and saved to the startup configuration as
well as to an FTP site.
Cisco SCE 2000 4xGBE Installation and Configuration Guide
5-24
Chapter 5
Connecting the Management Interfaces and Performing Initial System Configuration
OL-7824-06
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
