Gigastack Messages - Cisco WS-C2950-24 Configuration Manual
Software configuration guide
Hide thumbs
Also See for WS-C2950-24:
- Installation manual (220 pages) ,
- Hardware installation manual (156 pages) ,
- Datasheet (19 pages)
Table of Contents
Advertisement
Appendix A
System Error Messages
GigaStack Messages
78-6511-05
This section contains the GigaStack error messages.
GIGASTACK-6-LOOP_BROKEN
This message means that a loop formed by GigaStack modules is
Explanation
broken because of link loss. Link 2 of the Master Loop Breaker is re-enabled
to replace the broken line.
No action is required.
Action
GIGASTACK-6-LOOP_DETECTED
Explanation
This message means that a loop has been detected in the
GigaStack, and this GigaStack GBIC is selected as the Master Loop Breaker.
Link 2 of this GigaStack GBIC is disabled to break the loop.
No action is required.
Action
GIGASTACK-6-NO_LOOP_DETECT
Explanation
This message means that no acknowledgement for GigaStack loop
detection request is received from one of the links on a GigaStack GBIC.
Either the neighboring switch does not support the GigaStack Loop breaking
algorithm, or the link between the two GigaStack GBICs is broken. Under this
condition, a GigaStack loop topology is not automatically detected, and the
connectivity between switches in the stack could be lost.
Action
If loop topology is used in the GigaStack, make sure the latest software
is running on all switches in the stack. Check the GigaStack GBICs involved
to make sure they are functioning.
Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide
Error Message and Recovery Procedures
A-7
- Quick Links:
- Management Options
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
