Cisco WS-C3550-12G Software Configuration Manual page 393
Multilayer switch
Hide thumbs
Also See for WS-C3550-12G:
- User manual (436 pages) ,
- Manual (278 pages) ,
- Datasheet (19 pages)
Table of Contents
Advertisement
Chapter 17
Configuring System Message Logging
Command
Step 3
logging host
Step 4
logging file flash:filename
[max-file-size] [min-file-size]
[severity-level-number | type]
Step 5
end
Step 6
terminal monitor
Step 7
show running-config
Step 8
copy running-config startup-config
The logging buffered global configuration command copies logging messages to an internal buffer. The
buffer is circular, so newer messages overwrite older messages after the buffer is full. To display the
messages that are logged in the buffer, use the show logging privileged EXEC command. The first
message displayed is the oldest message in the buffer. To clear the contents of the buffer, use the clear
logging privileged EXEC command.
To disable logging to the console, use the no logging console global configuration command. To disable
logging to a file, use the no logging file [severity-level-number | type] global configuration command.
78-11194-03
Purpose
Log messages to a UNIX syslog server host.
For host, specify the name or IP address of the host to be used as the
syslog server.
To build a list of syslog servers that receive logging messages, enter this
command more than once.
For complete syslog server configuration steps, see the
UNIX Syslog Servers" section on page
Store log messages in a file in Flash memory.
•
For filename, enter the log message filename.
•
(Optional) For max-file-size, specify the maximum logging file size.
The range is 4096 to 2147483647. The default is 4069 bytes.
(Optional) For min-file-size, specify the minimum logging file size.
•
The range is 1024 to 2147483647. The default is 2048 bytes.
(Optional) For severity-level-number | type, specify either the logging
•
severity level or the logging type. The severity range is 0 to 7. For a
list of logging type keywords, see
default, the log file receives debugging messages and numerically
lower levels.
Return to privileged EXEC mode.
Log messages to a nonconsole terminal during the current session.
Terminal parameter-setting commands are set locally and do not remain
in effect after the session has ended. You must perform this step for each
session to see the debugging messages.
Verify your entries.
(Optional) Save your entries in the configuration file.
Catalyst 3550 Multilayer Switch Software Configuration Guide
Configuring System Message Logging
"Configuring
17-10.
Table 17-3 on page
17-9. By
17-5
- Quick Links:
- Table of Contents
- Front Panel View
- Ip Addresses
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
