Test Results; Fixed Disk Advanced Test (Fdat) - Lenovo M55p - ThinkCentre - 8808 Hardware Maintenance Manual
Hardware maintenance manual
Hide thumbs
Also See for M55p - ThinkCentre - 8808:
- User manual (116 pages) ,
- Benutzerhandbuch (98 pages) ,
- Manual do utilizador (98 pages)
Table of Contents
Advertisement
Press Esc at any time to stop the testing process.
Test results (N/A, PASSED, FAILED, ABORTED) are displayed in the field beside the test description and in
the test log. See "Viewing the test log" on page 46.
To select one or more tests, use the following procedure.
1. Open the corresponding test category.
2. Using the cursor movement keys, highlight the desired test.
3. Press the space bar. A selected test is marked by >>. Pressing the space bar again de-selects a test
and removes the >>.
4. Repeat steps 2 and 3 above to select all desired tests.
Test results
Diagnostics test results produce the following error code format:
Function Code
Failure Type
• Function Code:
Represents the feature or function within the PC.
• Failure Type:
Represents the type of error encountered.
• DeviceID:
Contains the component's unit-ID which corresponds to either a fixed disk drive, removable media drive,
serial or parallel port, processor, specific RIMM, or a device on the PCI bus.
• Date:
Contains the date when the diagnostic test was run. The date is retrieved from CMOS and displayed
using the YYYYMMDD format.
• ChkDigits:
Contains a 2-digit check-digit value to ensure the following:
– Diagnostics were run on the specified date.
– Diagnostics were run on the specified computer.
– The diagnostic error code is recorded correctly.
• Text:
Description of the error.
Note: See "Diagnostic error codes" on page 52 for error code listings.
Fixed disk advanced test (FDAT)
PC-Doctor Fixed-Disk
1
suite. The configurable capabilities of FDAT allow users to enable or disable specific tests, enable or disable
testing features, control the test log detail, alter testing parameters, and so on. FDAT tests for and reports
most commonly found errors on a fixed-disk drive and is able to test up to 128 SCSI and 4 IDE drives
(up to 132 total drives).
Drive information is gathered through FDAT's enumeration of available devices and user specific configuration
parameters located in the FDAT.INI. FDAT uses information supplied by these features to indicate specifically
1.
The terms fixed disk and hard disk are used interchangeably.
44
Hardware Maintenance Manual
DeviceID
Advanced Test module (FDAT) is a full-featured highly configurable fixed-disk test
Date
ChkDigits
Text
Hide quick links:
Advertisement
Table of Contents
