Table of Contents
Advertisement
.
Partition ID: 1
SN: 23A0509
Primary
Port 1
Partition ID: 1
SN: 23A0143
Primary
Port 1
Figure 4-26 RSA II Web interface: two-node partition configuration
You have completed the step to create partitions.
If you want to create a second partition in this complex, repeat the steps. You
may create partitions that are comprised of two, three, or four nodes.
4.8 Working with partitions
This section describes how to work with and manage your partitions, and the
various management and control features.
4.8.1 Managing partitions
You can start, reset, power off, and delete partitions. You can also swap between
Standalone and Multinode mode, and clear partition information in a complex.
Start a partition
All nodes in the partition power on immediately, after a partition is started.
To start a partition, select the Partition ID (PID) at the top of the blue symbolic
box at the primary node. Click Start (under Partition Control). The following
events occur, as shown in Figure 4-27 on page 229:
The selected partition starts immediately.
The system's state changes from Stopped to Started.
228
Planning, Installing, and Managing the IBM System x3950 M2
(Local)
Port 2
Port 3
Port 2
Port 3
System
Mode
Partition
Stopped
Valid
Multinode
Stopped
Valid
Multinode
Advertisement
Table of Contents
