Displaying The Configuration Register Value; Synchronizing The Configurations (Catalyst 8540 Msr) - Cisco Catalyst 8540 MSR Configuration Manual
Atm switch router software configuration guide
Hide thumbs
Also See for Catalyst 8540 MSR:
Table of Contents
Advertisement
Chapter 5
Configuring Redundancy
Caution
If no system image is specified in the startup configuration, the ROM monitor automatically boots the
first system image on the Flash PC card in slot0. If there is no system image on the Flash PC card, or the
Flash PC card is not available, the ROM monitor boots the first system image in bootflash. If there is no
system image in bootflash, the switch remains in ROM monitor mode.
Displaying the Configuration Register Value
To display the configuration register value, use the following privileged EXEC command:
Command
show version
The following example shows the configuration register value:
Switch# show version
Cisco Internetwork Operating System Software
IOS (tm) PNNI Software (cat8540m-WP-M), Version XX.X(X)WX(X),
Copyright (c) 1986-19XX by cisco Systems, Inc.
Compiled Mon XX-XXX-XX 10:15 by integ
Image text-base: 0x60010930, data-base: 0x606CE000
ROM: System Bootstrap, Version XX.XXX.X(X)WX(X) [BLD-JAGUAR120-4.0.9 ], E
Switch uptime is 3 weeks, 5 days, 23 hours, 30 minutes
System restarted by bus error at PC 0x6007EF24, address 0xFC
System image file is "bootflash:cat8540m-wp-mz.XXX-X.X.WX.X.XX"
cisco C8540MSR (R5000) processor with 65536K/256K bytes of memory.
R5000 processor, Implementation 35, Revision X.X (512KB Level 2 Cache)
Last reset from power-on
1 Ethernet/IEEE 802.3 interface(s)
9 ATM network interface(s)
507K bytes of non-volatile configuration memory.
8192K bytes of Flash PCMCIA card at slot 0 (Sector size 128K).
8192K bytes of Flash internal SIMM (Sector size 256K).
Secondary is up
Secondary has 0K bytes of memory.
Configuration register is 0x100 (will be 0x2102 at next reload)
Synchronizing the Configurations (Catalyst 8540 MSR)
During normal operation, the startup and running configurations are synchronized by default between
the two route processors. In the event of a switchover, the new primary route processor uses the current
configuration. Configurations synchronize either immediately from the command line or during route
processor switchover.
OL-7396-01
Synchronizing the Configurations (Catalyst 8540 MSR)
Purpose
Displays the configuration register value.
RELEASE SOFTWARE
ATM Switch Router Software Configuration Guide
5-5
Advertisement
Table of Contents
Troubleshooting
