Configuring A Soft Pvp With Priority; Configuring A Soft Pvc With Priority For A Ces Circuit; Configuring A Soft Pvc With Priority For Frame Relay Connections - Cisco Catalyst 8540 MSR Configuration Manual
Atm switch router software configuration guide
Hide thumbs
Also See for Catalyst 8540 MSR:
Table of Contents
Advertisement
Chapter 7
Configuring Virtual Connections
Command
Step 2
Switch(config-if)# end
Step 3
Switch# show atm vc interface atm
card/subcard/port vpi vci
If not priority is specified, the soft PVC is assigned a priority of 15 (lowest).
Note
If the atm svc-clear by-priority command is not enabled, none of the hold-priority configurations are
Note
considered when bandwidth is dropped on an interface.
Configuring a Soft PVP with Priority
To configure a soft PVP with priority, perform the following steps:
Command
Step 1
Switch(config-if)# atm soft-vp vpi vci
dest-address nsap vpi [hold-priority priority]
Step 2
Switch(config-if)# end
Step 3
Switch# show atm vp interface atm
card/subcard/port vpi vci
Configuring a Soft PVC with Priority for a CES Circuit
To configure a soft PVC with priority for a circuit emulation service (CES) circuit, use the following
command:
Command
Switch(config-if)# ces pvc 1 dest-address
nsap vpi vci vci vci [hold-priority priority]
Configuring a Soft PVC with Priority for Frame Relay Connections
To configure a soft PVC with priority between a Frame Relay connection and an ATM connection, use
the following command:
Command
Switch(config-if)# frame-relay soft-vc dlci
dest-address nsap vc vpi vci [hold-priority
priority]
OL-7396-01
Configuring Soft PVCs and Soft PVPs with Priority
Purpose
Switches to EXEC command mode.
Displays the soft PVC configuration information,
including the holding priority.
Purpose
Creates a soft PVP with a priority from 0 (high)
to 15 (low).
Switches to EXEC command mode.
Displays the soft PVP configuration information,
including the holding priority.
Purpose
Configures a soft PVC with priority on a CES
circuit.
Purpose
Configures a soft PVC with priority between
a frame relay connection and an ATM
connection.
ATM Switch Router Software Configuration Guide
7-35
Advertisement
Table of Contents
Troubleshooting
