Configuring Classical Ip Over Atm; Configuring Classical Ip Over Atm In An Svc Environment - Cisco Catalyst 8540 MSR Configuration Manual

Atm switch router software configuration guide

Hide thumbs Also See for Catalyst 8540 MSR:

Table of Contents

Configuring IP over ATM

This chapter describes how to configure IP over ATM on the ATM switch router. The primary use of IP

over ATM is for inband management of the ATM switch router.

This chapter provides advanced configuration instructions for the Catalyst 8540 MSR,

Catalyst 8510 MSR, and LightStream 1010 ATM switch routers. For further information about Layer 3

protocols over ATM, refer to the Guide to ATM Technology. For complete descriptions of the commands

mentioned in this chapter, refer to the ATM Switch Router Command Reference publication.

This chapter includes the following sections:

Configuring Classical IP over ATM

This section describes configuring a port on a ATM switch router to allow a classical IP-over-ATM

connection to the ATM switch router's route processor and optional ATM router module.

The following sections describe configuring the ATM switch router for classical IP over ATM in either

a switched virtual channel (SVC) or permanent virtual channel (PVC) environment.

This section describes classical IP over ATM in an SVC environment. It requires configuring only the

device's own ATM address and that of a single ATM Address Resolution Protocol (ARP) server into each

client device.

For a detailed description of the role and operation of the ATM ARP server, refer to the Guide to ATM

Configuring Classical IP over ATM, page 13-1

Mapping a Protocol Address to a PVC Using Static Map Lists, page 13-7

Policy-Based Routing, page 13-11

Configuring IP Load Sharing, page 13-13

C H A P T E R

ATM Switch Router Software Configuration Guide

Catalyst 8510 msr Lightstream 1010