Verifying A Switched Vc For Unstructured Ces - Cisco Catalyst 8540 MSR Configuration Manual

Atm switch router software configuration guide

Hide thumbs Also See for Catalyst 8540 MSR:

Table of Contents

Configuring Circuit Emulation Services

The following example shows how to configure the switched VC for unstructured CES (shown in

Use the show ces status command to confirm CES interface CBR 0/0/0 is up.

Switch# show ces status

------------- -------- --------- ----------- -----------

Use the show ces address command to determine the ATM address of the target CBR interface 0/0/1.

Switch# show ces addresses

[Information Deleted]

CES-IWF ATM Address(es):

47.0091.8100.0000.0004.ddec.d301.4000.0c80.0034.10

[Information Deleted]

Use the following commands to configure the switched VC on CES interface CBR 0/0/0:

Switch# config terminal

Enter configuration commands, one per line.

Switch(config)# interface cbr 0/0/0

Switch(config-if)# shutdown

Switch(config-if)# ces aal1 service unstructured

Switch(config-if)# ces circuit 0 circuit-name CBR-SVC-A

Switch(config-if)# ces svc 0 dest-address 47.0091.8100.0000.0004.ddec.d301.4000.0c80.0034.10

Switch(config-if)# no shutdown

Switch(config-if)# end

These commands perform the following processes:

Confirm that the CES switched VC is functioning correctly using the commands in the following section.

Verifying a Switched VC for Unstructured CES

To verify the unstructured switched VC configuration, use the following privileged EXEC commands:

End with CNTL/Z.

Select the interface to configure.

Shut down the interface.

Configure the CES as unstructured.

Configure the circuit number and circuit name.

Configure the SVC circuit ID to an CBR interface destination ATM address.

Re-enable the interface.

ATM Switch Router Software Configuration Guide

Configuring T1/E1 CES SVCs

vpi 0 vci 1040

Catalyst 8510 msr Lightstream 1010