Configuring Rspan; Rspan Configuration Guidelines - Cisco Catalyst 3120 Software Manual
Catalyst blade switch for hp
Hide thumbs
Also See for Catalyst 3120:
- Command reference manual (982 pages) ,
- Hardware installation manual (76 pages) ,
- Manual (42 pages)
Table of Contents
Advertisement
Chapter 29
Configuring SPAN and RSPAN
Command
Step 5
monitor session session_number
destination {interface interface-id [, | -]
[encapsulation replicate]}
Step 6
end
Step 7
show monitor [session session_number]
show running-config
Step 8
copy running-config startup-config
To monitor all VLANs on the trunk port, use the no monitor session session_number filter global
configuration command.
This example shows how to remove any existing configuration on SPAN session 2, configure SPAN
session 2 to monitor traffic received on Gigabit Ethernet trunk port 2, and send traffic for only VLANs 1
through 5 and VLAN 9 to destination Gigabit Ethernet port 1.
Switch(config)# no monitor session 2
Switch(config)# monitor session 2 source interface gigabitethernet1/0/2 rx
Switch(config)# monitor session 2 filter vlan 1 - 5 , 9
Switch(config)# monitor session 2 destination interface gigabitethernet1/0/1
Switch(config)# end
Configuring RSPAN
These sections contain this configuration information:
•
•
•
•
•
•
RSPAN Configuration Guidelines
Follow these guidelines when configuring RSPAN:
•
•
OL-12247-01
RSPAN Configuration Guidelines, page 29-17
Configuring a VLAN as an RSPAN VLAN, page 29-18
Creating an RSPAN Source Session, page 29-19
Specifying VLANs to Filter, page 29-20
Creating an RSPAN Destination Session, page 29-21
Creating an RSPAN Destination Session and Configuring Incoming Traffic, page 29-22
All the items in the
"SPAN Configuration Guidelines" section on page 29-12
As RSPAN VLANs have special properties, you should reserve a few VLANs across your network
for use as RSPAN VLANs; do not assign access ports to these VLANs.
Purpose
Specify the SPAN session and the destination port (monitoring port).
For session_number, specify the session number entered in Step 3.
For interface-id, specify the destination port. The destination interface
must be a physical port; it cannot be an EtherChannel, and it cannot
be a VLAN.
(Optional) [, | -] Specify a series or range of interfaces. Enter a space
before and after the comma; enter a space before and after the hyphen.
(Optional) Enter encapsulation replicate to specify that the
destination interface replicates the source interface encapsulation
method. If not selected, the default is to send packets in native form
(untagged).
Return to privileged EXEC mode.
Verify the configuration.
(Optional) Save the configuration in the configuration file.
Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide
Configuring SPAN and RSPAN
apply to RSPAN.
29-17
Advertisement
Chapters
Table of Contents
Troubleshooting
