Honeywell T7351 Product Data page 4
Commercial programmable thermostat for single- or multi-stage conventional/heat pump systems
Hide thumbs
Also See for T7351:
- User manual (13 pages) ,
- Installation instructions manual (12 pages) ,
- Information (4 pages)
Table of Contents
Advertisement
T7351 COMMERCIAL PROGRAMMABLE THERMOSTAT
CAUTION
Equipment Damage Hazard.
Can damage the TIM connection beyond repair.
Disconnect the TIM cable prior to opening or closing
the thermostat cover.
NOTE: Allow sufficient clearance below the thermostat to
plug in the TIM cable.
Install the remote-mounted sensor(s) about 5 ft. (1.5 m) above
the floor in an area with good air circulation at average
temperature. (See Fig. 2.)
NOTE: Only TR21 models with neither setpoint adjustment
nor bypass can be used for temperature averaging.
NO
NO
Fig. 2. Typical Location of Thermostat or Remote-Mounted
IMPORTANT
To avoid electrical interference, which can cause
erratic performances, keep wiring runs as short as
possible and do not run thermostat wires adjacent to
the line voltage electrical distribution systems. Use
shielded cable (Belden type 8762 or equivalent for
2-wire). The cable shield must be grounded only at
the controlled equipment case.
Mounting Subbase
The subbase mounts horizontally or vertically.
IMPORTANT
• When using the internal temperature sensor, the
device must be mounted horizontally (with the LCD
facing upwards). Precise leveling is not needed.
• When using remote sensors, thermostat mounting
orientation does not matter.
Wall mounting (using standard drywall screws) is standard.
Mounting to a 2 in.(50.8 mm) by 4 in. (101.6 mm) wiring box
can be accomplished:
— for a horizontal box, no extra hardware is required.
— for a vertical box, part 209651A is required.
— Mount to European standard wall box 2.4 in. (having 61 mm
between mounting screws in a horizontal line) with or
without adaptive hardware.
63-2666—02
YES
NO
5 FEET
(1.5 METERS)
Sensor.
1. Position and level the subbase.
NOTE: A level wallplate is only for appearance. The
thermostat functions properly when not level.
2. Use a pencil to mark the mounting holes.
(Refer to Fig. 6.)
3. Remove the subbase from the wall and drill two 3/16 in.
(4.76 mm) holes in the wall (if drywall) as marked. For
firmer material such as plaster or wood, drill two 7/32 in.
(5.56 mm) holes.
4. Gently tap anchors (provided) into the drilled holes until
flush with the wall.
5. Position the subbase over the holes, pulling wires
through the wiring opening.
6. Loosely insert the mounting screws into the holes.
7. Tighten mounting screws.
TR21
TR21
M4823A
Fig. 3. Four TR21 Sensors providing a Temperature
Averaging Network for T7351 Thermostat.
T4
1
Fig. 4. Two TR21-A Sensors Providing a Temperature
Averaging Network for T7351 Thermostat.
4
SUBBASE
T4
T3
TR21
T
T
T
T
TR21
T
T
T
T
M29184
T7350 SUBBASE
T4
T3
T3
T4
T3
1
1
TR21-A
TR21-A
THE TR21-A IS A 10K OHM SENSOR.
M29256
Advertisement
Table of Contents
