Setting - Honeywell T7351 Product Data
Commercial programmable thermostat for single- or multi-stage conventional/heat pump systems
Hide thumbs
Also See for T7351:
- User manual (13 pages) ,
- Installation instructions manual (12 pages) ,
- Information (4 pages)
Table of Contents
Advertisement
Occupancy
Scheduled
Motion Sensor
Period
Signal
Occupied
No Sensor Wired
Occupied
Motion Sensed
Occupied
No Motion Sensed
Not Occupied No Sensor Wired Not Occupied Fan On Fan Off
Not Occupied
Motion Sensed
Not Occupied No Motion Sensed Not Occupied Fan On Fan Off
a
In heat mode, when set for conventional heat, the equipment (i.e. plenum switch) could power the fan despite the T7350.
INSTALLER SETUP
For most applications, the thermostat factory settings do not
need to be charged. Review the factory settings in Table 2.
NOTE: When power is first applied to the thermostat, the
display will show all segments (See Fig. 9).
Temporary Standby
Not Occupied12
StartTime
MonTueWedThuFri
System
Em Heat
Off Cool Auto
Fig. 9. LCD Display of all Segments.
CAUTION
Possible Equipment Damage.
Fan must be running when system is operating.
Heat pump and electric heat systems must be
configured correctly to prevent equipment damage
caused by the system running without the fan.
Table 4. T7351 Intelligent™ Fan ON control logic
Effective
Occupancy
Yes
Occupied
Fan On Fan On
Occupied
Fan On Fan On
Standby
Fan On Fan Off
Not Occupied Fan On Fan Off
Temperature
Occupied
Not Occupied
HEAT
COOL
HEAT
Schedule
Day
Occupied
Not Occupied
Fig. 8. Thermostat Key Locations.
Set
Set Schedule
Room
AM
PM
MinsDays
SatSunHol
Fan
Dehumid
OnAuto
T7351 COMMERCIAL PROGRAMMABLE THERMOSTAT
Call for
Heat/Cool
No
Effective Occupancy is Standby. Standby
setpoints are used and it assumes that the
a
space is unoccupied. Fan is on only when there
is a call for heating or cooling.
a
Occupancy sensor will only be active during
scheduled Occupied periods. During scheduled
a
Not Occupied periods, the effective occupancy
will always be Not Occupied.
a
Set Day/Time
Day
Time
COOL
System
Clear
Start Time
Copy
HEAT COOL
Setup Using Keypad
The installer uses the Installer Setup to customize the
thermostat to specific systems.
A combination of key presses are required to use the Installer
Setup features.
1. To enter the Installer Setup, press and hold both the Run
%
Schedule and the Copy keys until DEGREES 00 (or
DEGREES 01) displays.
NOTE: Installer Setup will display WAIT and is
M19611
2. To advance to the next Installer Setup number, press
.
NOTE: Pressing Run/Copy again while in this mode
3. To return to a Setup item, cycle through the options.
4. To change a setting, use the up
5. To exit the Installer Setup, press Run Schedule.
6. Display prompts SAV CFG (save configuration).
7
Notes
Override
Temporary
Temporary
Occupied
Not Occupied
Fan
Run
Schedule
ON AUTO
M19610
unavailable for 30 seconds after power up.
displays the T7351 firmware version number.
or down
key.
63-2666—02
Advertisement
Table of Contents
