used. The WEP, 802.1x, and WPA functions can be used
only if the network supports them.
To enter the settings for the selected security mode, select
WLAN security
settings.
Security settings for WEP
WEP key in use
— Select the wired equivalent privacy
●
(WEP) key number. You can create up to four WEP keys.
The same settings must be entered on the WLAN access
point device.
Authentication type
●
authentication type between your device and the
WLAN access point device.
WEP key settings
— Enter
●
of the key),
WEP key format (ASCII
and
WEP key
(the WEP key data in the selected format).
Security settings for 802.1x and WPA/WPA2
WPA/WPA2
— Select the means of authentication:
●
EAP
to use an extensible authentication protocol (EAP)
plug-in, or
Pre-shared key
Complete the appropriate settings:
EAP plug-in settings
●
service provider instructs.
Pre-shared key
●
password must be entered on the WLAN access point
device.
156
— Select
Open
or
Shared
WEP encryption
or Hexadecimal),
to use a password.
— Enter the settings as your
— Enter a password. The same
WPA2 only mode
●
allowed to establish a connection in this mode.
Advanced WLAN settings
Select
Options
following:
IPv4 settings
●
the subnet IP address, the default gateway, and the IP
addresses of the primary and secondary DNS servers.
Contact your internet service provider for these
addresses.
for the
IPv6 settings
●
Ad-hoc channel
●
channel number (1-11) manually, select
(length
defined.
Proxy server address
●
proxy server.
Proxy port number
●
Packet data settings
Press
, and select
Packet
data.
The packet data settings affect all access points using a
packet data connection.
Packet data connection
●
available
packet data, the device registers to the packet data
— Only WPA2 enabled devices are
Advanced settings
>
— Enter the IP address of your device,
— Define the type of DNS address.
(only for Ad-hoc) — To enter a
— Enter the address for the
— Enter the proxy port number.
Tools
Settings
>
— If you select
and you are in a network that supports
© 2009 Nokia. All rights reserved.
and from the
User
Connection
>
>
When