Create A Virtual Stack Unit On An S-Series Stack; Display Information About An S-Series Stack - Dell Force10 C150 Configuration Manual
Ftos configuration guide ftos 8.4.2.7 e-series terascale, c-series, s-series (s50/s25)
Hide thumbs
Also See for Force10 C150:
- Manual (57 pages) ,
- Manual (66 pages) ,
- Quick start manual (33 pages)
Table of Contents
Advertisement
Create a Virtual Stack Unit on an S-Series Stack
Use virtual stack units to configure ports on the stack before adding a new unit, or to prevent FTOS from
assigning a particular stack-number.
Task
Create a virtual stack unit.
Display Information about an S-Series Stack
Task
Display for stack-identity, status, and
hardware information on every unit in a
stack
(Figure
50-18).
Display most of the information in
system
, but in a more convenient tabular
form
(Figure
50-19).
Display the same information in
system
, but only for the specified unit
(Figure
50-19).
Display topology and stack link status for
the entire stack. The available options
show system stack-port
separate the
output into topology information from link
status information
1036
|
Stacking S-Series Switches
show
show
(Figure
50-19).
Command Syntax
stack-unit provision
Command Syntax
show system
show system brief
show system stack-unit
show system stack-ports
[
Command Mode
CONFIGURATION
Command Mode
EXEC Privilege
EXEC Privilege
EXEC Privilege
status
topology
|
]
EXEC Privilege
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
