Table of Contents
Advertisement
CAUTION:
The power control button on the device and the power switch on the power
supply do not turn off the electrical current supplied to the device. The device
also might have more than one power cord. To remove all electrical current
from the device, ensure that all power cords are disconnected from the power
source.
Statement 8
CAUTION:
Never remove the cover on a power supply or any part that has the following
label attached.
Hazardous voltage, current, and energy levels are present inside any
component that has this label attached. There are no serviceable parts inside
these components. If you suspect a with one of these parts, contact a service
technician.
To install a hot-swap power supply in the MAX5 memory expansion module,
complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the server is in a rack, at the back of the server, pull back the
3. If you are installing a hot-swap power supply into an empty bay, remove the
4. Touch the static-protective package that contains the hot-swap power supply to
5. Grasp the handle on the rear of the power supply and slide the power supply
80
IBM System x3850 X5 and x3950 X5 Types 7145 and 7146: Installation and User's Guide
on page 32.
cable-management arm to gain access to the rear of the server and the power
supply.
power-supply filler panel from the power-supply bay.
any unpainted metal surface on the server; then, remove the power supply from
the package and place it on a static-protective surface.
forward into the power-supply bay until it clicks. Make sure that the power
supply connects firmly into the power-supply connector.
Advertisement
Table of Contents
