Table of Contents
Advertisement
Chapter
AUSM LED Indicators
The AUSM LED indicators are described in Table 4-1. All LED indicators are located on the faceplate
of the front card.
Table 4-1
Type of LED
ACT
STBY
FAIL
PORT
Release 5.0, Part Number 78-6430-03 Rev. D0, November 2003
AUSM LED Indicators
Color
Meaning
Green
On indicates the card set is in active mode.
Yellow
•
Slow blink without the Active LED indicates the card is in the
boot state.
Fast blink with the Active LED indicates the card is being
•
downloaded.
Fast blink indicates the service module is passing BRAM channel
•
information to the ASC.
Steady yellow indicates the card is in Standby mode and the
•
firmware is executing ADMIN code.
Red
•
Steady Red with Active and Standby LEDs off indicates either
the card is in the Reset condition or the card has failed.
•
Steady Red with Active LED on indicates the card was active
prior to failing.
•
Steady Red with Standby LED on indicates the card was standby
prior to failing.
Green
Green indicates the port is active.
Red
Red indicates a local alarm on the port.
Yellow
Yellow indicates a remote alarm on the port.
•
•
Off indicates the port has not been activated (upped).
ATM UNI Service Module
Cisco MGX 8220 Installation and Configuration
4-19
Advertisement
Table of Contents
Troubleshooting
