Table of Contents
Advertisement
Chapter
Table 8-3
Error Number
1213
1214
1215
1216
1217
1218
1219
1220
1221
1222
1223
1224
1225
1226
1227
1228
1229
1230
Release 5.0, Part Number 78-6430-03 Rev. D0, November 2003
ASC Log Codes (continued)
Display Log String
NULL
NULL
switch reason
switch reason
switch reason
NULL
switch reason
informational
communication up, slot
communication down,
slot
card inserted, slot
card removed, slot
SM card state change
Both Mastership
Asserted, cardState
Major Alarm:
Connections exist on
removed SM
Clear Alarm: Connections
exist on removed SM
card ready de asserted,
slot n
standby F/W update
failed
Detail Description
Standby card firmware update, as active card firmware
revision is higher than the standby revision.
Standby firmware update when active is native to shelf
and standby is not native.
Standby card has been allowed to gain mastership as the
firmware revision in the standby card is higher than the
active firmware.
Standby card has been allowed mastership because the
active was not native to shelf and the standby was native
to shelf.
Not used.
Overrides do not change standby if standby firmware
revision is Release 2 or Release 3.
Standby card has been allowed mastership because
standby firmware version is higher than active.
SMM-related information regarding the card state and
other information useful for debugging and
administration has been logged.
Message received, which states that an SM card is
responding while polling. Additional information about
the slot number and the card state is also displayed.
Message received, which states that an SM card is not
responding while polling.
SM card insertion detected while monitoring the slot
states of the shelf.
SM card removal detected while monitoring the slot
states of the shelf.
Message received, which reports the change in card
state. Information about the present card state is also
displayed.
Both cards have asserted mastership state.
Connections exist on the removed SM card and a major
alarm has been logged.
Clear the alarm caused by the switchover of a card with
existing connections by a new card.
SM card failure detected. Additional Information about
the slot number is displayed.
Error occurred while updating the firmware version in
the standby card. Operation incomplete.
Cisco MGX 8220 Installation and Configuration
Log Codes
8-7
Advertisement
Table of Contents
Troubleshooting
