Table of Contents
Advertisement
19
STEP 1
STEP 2
STEP 3
389
Click Security > SSH Client > Change User Password on SSH Server.
Enter the following fields:
•
Server Definition—Define the SSH server by selecting either By IP
Address or By Name. Enter the server name or IP address of the server in
the Server IP Address/Name field.
•
IP Version—If you selected to specify the SSH server by IP address, select
whether that IP address is an IPv4 or IPv6 address.
•
IP Address Type—If the SSH server IP address is an IPv6 address, select
the IPv6 address type. The options are:
-
Link Local—The IPv6 address uniquely identifies hosts on a single
network link. A link local address has a prefix of FE80, is not routable, and
can be used for communication only on the local network. Only one link
local address is supported. If a link local address exists on the interface,
this entry replaces the address in the configuration.
-
Global—The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
•
Link Local Interface—Select the link local interface from the list of
interfaces.
•
Server IP Address/Name—Enter either the IP address of the SSH server or
its name, depending on what was selected in Server Definition.
•
Username—This must match the username on the server.
•
Old Password—This must match the password on the server.
•
New Password—Enter the new password and confirm it in the Confirm
Password field.
Click Apply. The password on the SSH server is modified.
Cisco Small Business 300 Series Managed Switch Administration Guide
Security: SSH Client
SSH Client Configuration Through the GUI
Advertisement
Table of Contents
