Police Command (Single-Rate) - Cisco 10000 Series Configuration Manual
Quality of service configuration guide
Hide thumbs
Also See for 10000 Series:
- Configuration manual (370 pages) ,
- Troubleshooting manual (70 pages) ,
- Installation manual (14 pages)
Table of Contents
Advertisement
Single-Rate Color Marker for Traffic Policing
police Command (Single-Rate)
To configure traffic policing based on bits per second, use the police command in policy-map class
configuration mode. To remove traffic policing from the configuration, use the no form of this command.
By default, this command is disabled.
police [cir] bps [bc] burst-normal [be] burst-excess [conform-action action]
[exceed-action action] [violate-action action]
no police [cir] bps [bc] burst-normal [be] burst-excess [conform-action action]
[exceed-action action] [violate-action action]
Syntax Description
cir
bps
bc burst-normal
be burst-excess
conform-action action
exceed-action action
violate-action action
See
For information about conforming, exceeding, and violating traffic, see the
police Command" section on page 6-7
Cisco 10000 Series Router Quality of Service Configuration Guide
6-6
(Optional) Committed information rate (CIR). Indicates an average rate at
which the policer meters traffic. CIR is based on the interface shape rate.
Specifies the average rate in bits per second (bps). Valid values are from
8,000 to 2,488,320,000 bps. If you only specify police bps, the router
transmits the traffic that conforms to the bps value and drops the traffic that
exceeds the bps value. For information on how the router calculates the
policing rate, see the
(Optional) Normal or committed burst (bc) size used by the first token
bucket for policing. The burst-normal specifies the bc value in bytes. Valid
values are from 1 to 512,000,000. The default is 9,216 bytes. For more
information, see the
page
(Optional) Excess burst (be) size used by the second token bucket for
policing. The burst-excess specifies the excess burst in bytes. Valid values
are from 0 to 1,024,000,000 bytes. The default is 0. You must specify
burst-normal before you specify burst-excess. For more information, see
the
"Committed Bursts and Excess Bursts" section on page
Note
Specifies the action to take on packets that conform to the rate limit. The
default action is transmit. You must specify burst-excess before you specify
the conform-action.
Specifies the action to take on packets that exceed the rate limit, but not the
PIR. The default action is drop. You must specify the conform-action
before you specify the exceed-action.
(Optional) Specifies the action to take on packets that continuously exceed
the PIR rate limit. The default action is the same as the exceed-action. You
must specify the exceed-action before you specify the violate-action.
Table 6-1 on page 6-3
for a description of each action you can specify in the police command.
"Policing Rate Granularity" section on page
"Committed Bursts and Excess Bursts" section on
6-21.
When the be value equals 0, we recommend that you set the egress
bc value to be greater than or equal to the ingress bc value plus 1.
Otherwise, packet loss can occur. For example:
be = 0
egress bc >= ingress bc + 1
Chapter 6
Policing Traffic
6-25.)
6-21.
"Usage Guidelines for the
OL-7433-09
Advertisement
Chapters
Table of Contents
