Cisco 10000 Series Configuration Manual page 612

Quality of service configuration guide

Hide thumbs Also See for 10000 Series:

Table of Contents

Shaping PPPoE Over VLAN Sessions Using RADIUS

Router(config-pmap-c)# bandwidth

{bandwidth-kbps | percent percentage |

remaining percent percentage} account

{{{qinq | dot1q} {aal5 | aal3}

{subscriber-encapsulation}} |

{user-defined offset [atm]}}

Router(config-pmap-c)# exit

Router(config-pmap)# policy-map

policy-map-name

Router(config-pmap)# class class-default

Cisco 10000 Series Router Quality of Service Configuration Guide

aal3 specifies the ATM Adaptation Layer 5 that supports both

connectionless and connection-oriented links. You must specify

either aal3 or aal5.

subscriber-encapsulation specifies the encapsulation type at the

subscriber line.

user-defined indicates that the router is to use the offset you

specify when calculating ATM overhead.

offset specifies the offset size the router is to use when calculating

ATM overhead. Valid values are from -63 to 63 bytes.

The router configures the offset size if you do not specify

the offset option.

atm applies ATM cell tax in the ATM overhead calculation.

Configuring both the offset and atm options adjusts the

packet size to the offset size and then adds ATM cell tax.

Exits policy-map class configuration mode.

Creates or modifies the parent policy.

policy-map-name is the name of the parent policy map. The name

can be a maximum of 40 alphanumeric characters.

Configures or modifies the parent class-default class.

You can configure only the class-default class in a parent

policy. Do not configure any other traffic class.

Configuring Dynamic Subscriber Services

Chapters

Table of Contents