Configuring Per Session Service Policy Using Radius - Cisco 10000 Series Configuration Manual
Quality of service configuration guide
Hide thumbs
Also See for 10000 Series:
- Configuration manual (370 pages) ,
- Troubleshooting manual (70 pages) ,
- Installation manual (14 pages)
Table of Contents
Advertisement
Chapter 18
Regulating and Shaping Subscriber Traffic
Command
Step 7
Router(config-pmap)# police parameters
Step 8
Router(config)# interface
virtual-template number
Step 9
Router(config-if)# service-policy {input
| output} policy-map-name
Do not apply service policies with CBWFQ actions to a VAI using a virtual template. The Cisco 10000
Note
series router supports queuing only when you apply the service policy to a VC. For RBE sessions, apply
the service policy to the ATM VC or ATM subinterface.
Configuring per Session Service Policy Using RADIUS
To configure per session service policy, do the following:
•
•
•
•
For information on creating a class map and policy map, see the
Note
Limiting" section on page
You must configure the RADIUS server on the Cisco 10000 series router. The "Configuring RADIUS"
chapter in the Cisco IOS Security Configuration Guide, Release 12.2 describes how to set up RADIUS
for authentication, authorization, and accounting (AAA). It includes the following sections that are
relevant to configuring RADIUS on the Cisco 10000 series router:
•
•
•
•
•
•
•
OL-7433-09
Configure the RADIUS server on the router.
Create a class map.
Create a policy map.
Apply the service policy to the RADIUS AAA user profile.
18-9.
Configuring the Router to RADIUS Server Communication (Required)
Configuring the Router to Use Vendor-Specific RADIUS Attributes (Required)
Configuring the Router for Vendor-Proprietary RADIUS Server Communication (Optional)
Configuring the Router to Query RADIUS Server for Static Routes and IP Addresses (Optional)
Configuring the Router to Expand Network Access Server Port Information (Optional)
Configuring AAA Server Groups (Optional)
Configuring AAA Server Groups with Deadtime (Optional)
Purpose
Specifies the actions to be taken on the traffic.
For more information, see
Note
Repeat Steps 2 through 6 for each user behind a
multiservice subscriber.
Creates and configures the virtual template you specify. Enters
interface configuration mode.
number identifies the virtual template.
Attaches the policy map to the virtual template. All VAIs using
the virtual template interface inherit the IP QoS parameters
defined in the policy map.
policy-map-name is the name of a previously configured policy
map. In this case, it is the name of the policy map you specified
in Step 5.
Cisco 10000 Series Router Quality of Service Configuration Guide
Subscriber-Based IP Quality of Service
Chapter 6, "Policing Traffic."
"Configuring per Session Rate
18-11
Advertisement
Chapters
Table of Contents
