Removing And Replacing The Server Front Cover - Cisco UCS C210 Installation And Service Manual
C-series rack-mount servers generations m1 and m2
Hide thumbs
Also See for UCS C210:
- Installation and service manual (124 pages) ,
- Configuration manual (88 pages) ,
- Setup (10 pages)
Table of Contents
Advertisement
Chapter
Removing and Replacing the Server Front Cover
It is not necessary to remove the front cover unless instructed to do so in a replacement procedure.
Note
To remove or replace the front cover of the server, follow these steps:
Remove a front cover:
Step 1
a.
b.
c.
Replace a front cover:
Step 2
a.
b.
c.
Figure 3-4
1
1
OL-20887-02
Remove the server top cover, as described in
page
3-10.
Use a Number 1 Phillips-head screwdriver to remove the 12 screws that secure the front cover. There
are six screws on the upper surface and three screws on each side of the front cover (see
Lift the front cover straight up off of the chassis.
Set the front cover back in place, aligning the screw holes in the cover with those in the chassis. The
crescent-shaped cut-out on the cover goes toward the server rear.
Replace the 12 securing screws.
Replace the top cover as described in
Removing the Front Cover of the Server
Front cover, with 6 screws on the upper
surface and 3 screws on each side
Removing and Replacing the Server Top Cover,
Removing and Replacing the Server Top Cover, page
Cisco UCS C210 Server Installation and Service Guide
Figure
3-4).
3-10.
3-11
Hide quick links:
Advertisement
Table of Contents
