Running A Product Check - Epson WorkForce WF-M1030 User Manual
Hide thumbs
Also See for WorkForce WF-M1030:
- Important safety instructions manual (13 pages) ,
- Start here (4 pages) ,
- Specification (2 pages)
Table of Contents
Advertisement
Light status
The
power,
ink lights are flashing fast
The
paper and
are on
Note: The ink pads in the printer collect, distribute, and contain the ink that is not used on printed pages.
During the life of your product it may reach a condition where either satisfactory print quality cannot be
maintained or the ink pads have reached the end of their usable life. The Epson Status Monitor, your
LCD, or lights on the control panel will advise you when these parts need replacing. If this happens
during the standard warranty of the product, the exchange of the product or replacement of the pads is
covered under the standard warranty. If the product is out of warranty, the pads can be replaced by any
Epson authorized service provider. The waste ink pads are not a user-serviceable part.
Parent topic:
Related references
Paper Jam Problems
Where to Get Help
Related topics
Loading Paper
Running a Product Check
Running a product check helps you determine if the printer is operating properly.
1. Press the
2. Disconnect any interface cables connected to your product.
3. Load plain paper in the product.
Condition/solution
An unknown product error has occurred. Turn the product off. Make
paper, and
sure no paper is jammed in the product, then turn the product back on
again. If the error continues, contact Epson for support.
ink lights
An error has occurred during firmware updating. Connect your product
using a USB cable and try downloading the Firmware Update from
Epson's support website. If the error continues, contact Epson for
support.
Solving Problems
power button to turn off the printer.
73
Advertisement
Table of Contents
