Table of Contents
Advertisement
6.
Insert the Red Hat
OK, then press <Enter>.
Insert your driver disk into /dev/fd0
and press "OK" to continue.
The drivers for the RAID card are installed to the system.
7.
When asked if you will load additional RAID controller drivers, select No, then
press <Enter>.
Do you wish to load any more
driver disks?
8.
Follow the onscreen instructions to finish the OS installation.
9.
If you install RHEL AS5, when the installation is completed, DO NOT click
Reboot. Press <Ctrl> + <Alt> + <F2> to switch to the command-line interface
from graphic user interface.
10. Type the following commands when using a USB floppy.
cat /proc/partitions
Write down the Major and Minor number before sdb for later use.
mknod /dev/sdb b [major number] [minor number]
mkdir /mnt/driver
mount /dev/sdb /mnt/driver
cd /mnt/driver
sh replace_ahci.sh
reboot
7-14
Enterprise RAID driver disk to the floppy disk drive, select
®
Insert Driver Disk
OK
More Driver Disks?
Yes
No
Back
Chapter 7: Driver installation
Advertisement
Table of Contents
