Sfp-Module Ports; Verify Port Connectivity - Cisco IE 3010 Getting Started Manual
Hide thumbs
Also See for IE 3010:
- Hardware installation manual (98 pages) ,
- Installation instructions manual (30 pages) ,
- Hardware installation manual (88 pages)
Table of Contents
Advertisement
Cisco IE 3010 Switch Getting Started Guide
SFP-Module Ports
Step 1
Grasp the module on the sides, and insert it
into the switch slot until you feel the
connector snap into place.
Step 2
Connect an appropriate cable to the module
port. Insert the other cable end into the other
device.
Verify Port Connectivity
78-19582-02
For a list of supported modules, see the release notes on Cisco.com. For detailed
instructions on installing, removing, and connecting to SFP modules, see the SFP
module documentation.
After you connect the switch port and another device, the port LED turns amber
while the switch establishes a link. This process takes about 30 seconds, and then
the LED turns green. If the LED turns off, the target device might not be turned
on, there might be a cable problem, or there might be a problem with the adapter
in the target device.
Cisco IE 3010 Switch Getting Started Guide
C i sc o IE
30 10
C i sc o IE
30 10
23
Advertisement
Table of Contents
