Power-On Password; Hard Disk Password; Supervisor Password; How To Remove The Power-On Password - Lenovo ThinkPad X230 Tablet Manual
Thinkpad x230; thinkpadx230i
Hide thumbs
Also See for ThinkPad X230 Tablet:
- (206 pages) ,
- Benutzerhandbuch (203 pages) ,
- Manual de utilizador (198 pages)
Table of Contents
Advertisement
Power-on password
A power-on password (POP) protects the system from being powered on by an unauthorized person. The
password must be entered before an operating system can be booted. For how to remove the POP, see
"How to remove the power-on password" on page 31.
Hard disk password
There are two hard disk passwords:
• User hard disk password - for the user
• Master hard disk password - for the system administrator, who can use it to get access to the hard disk
even if the user has changed the user hard disk password.
Note: There are two modes for the hard disk password: User only and Master + User. The Master + User
mode requires two hard disk passwords; the system administrator enters both in the same operation. The
system administrator then provides the user hard disk password to the system user.
Attention: If the user hard disk password has been forgotten, check whether a master hard disk password
has been set. If a master hard disk password has been set, it can be used to access the hard disk drive. If
no master hard disk password is available, neither Lenovo nor Lenovo authorized service technicians
provide any services to reset either the user hard disk password or the master hard disk password, or
to recover data from the hard disk drive. To put the system back to operational status, the only Lenovo
and Lenovo-authorized service solution would be to replace the hard disk drive or solid-state drive with
a scheduled fee.
For instructions on how to remove the hard disk password, see "How to remove the hard disk password"
on page 32.
Supervisor password
A supervisor password protects the system information stored in the ThinkPad Setup program. The user
must enter the supervisor password in order to get access to the ThinkPad Setup program and change the
system configuration.
Attention: If the supervisor password has been forgotten and cannot be made available to the service
technician, there is no service procedure to reset the password. The system board must be replaced for
a scheduled fee.
How to remove the power-on password
To remove a power-on password that you have forgotten, do the following:
If no supervisor password has been set, do the following to remove the power-on password:
1. Turn off the computer.
2. Remove the battery pack. For instructions on how to remove the battery pack, see "1020 Battery
pack" on page 63.
3. Remove the backup battery. For instructions on how to remove the backup battery, see "1080 Backup
battery" on page 72.
4. Turn on the computer and wait until the POST ends. After the POST ends, the password prompt will not
be displayed. The power-on password has been removed.
5. Reinstall the backup battery and the battery pack.
If a supervisor password has been set and is known to the service technician, do the following to remove
the power-on password:
.
Chapter 4
Related service information
31
- Quick Links:
- Beep Symptoms
Hide quick links:
Advertisement
Table of Contents
