No-Beep Symptoms; Lcd-Related Symptoms - Lenovo ThinkPad X230 Tablet Manual
Thinkpad x230; thinkpadx230i
Hide thumbs
Also See for ThinkPad X230 Tablet:
- (206 pages) ,
- Benutzerhandbuch (203 pages) ,
- Manual de utilizador (198 pages)
Table of Contents
Advertisement
Table 4. Beep symptoms (continued)
Symptom or error
Three short beeps, pause, three more short beeps, and
one short beep.
One short beep, pause, three short beeps, pause, three
more short beeps, and one short beep.
Only the cursor appears.
Four cycles of four short beeps and a blank screen.
Five short beeps and a blank screen.
No-beep symptoms
Table 5. No-beep symptoms
Symptom or error
No beep, power-on indicator on, LCD blank, and no
POST.
No beep, power-on indicator on, and LCD blank during
POST.
The power-on password prompt appears.
The hard disk password prompt appears.
LCD-related symptoms
Important: The TFT LCD for the notebook computer contains many thin-film transistors (TFTs). The
presence of a small number of dots that are missing, discolored, or always lighted is characteristic of TFT
LCD technology, but excessive pixel problems can cause viewing concerns.
If the LCD you are servicing has two or less visible defective pixels, it should not be considered faulty.
However, if the LCD has three or more visible defective pixels, it will be deemed as defective by Lenovo and
it should be replaced.
Notes:
• This policy applies to all ThinkPad Notebooks purchased on 1 January, 2008 or later.
• Lenovo will not provide warranty replacement if the LCD is within specifications because we cannot
guarantee that any replacement LCD will have zero pixel defects.
• One pixel consists of R, G, B sub-pixels.
Table 6. LCD-related symptoms
Symptom or error
No beep, power-on indicator on, and a blank LCD during
POST.
• LCD backlight not working.
• LCD too dark.
• LCD brightness cannot be adjusted.
• LCD contrast cannot be adjusted.
40
Hardware Maintenance Manual
FRU or action, in sequence
1. Memory module.
2. System board.
Reinstall the operating system.
System board (security chip)
System board
FRU or action, in sequence
1. Ensure that every connector is connected tightly
and correctly.
2. Memory module.
3. System board.
1. Reseat memory module.
2. System board.
A power-on password or a supervisor password is set.
Type the password and press Enter.
A hard disk password is set. Type the password and
press Enter.
FRU or action, in sequence
System board.
1. Reseat the LCD connectors.
2. LCD assembly.
3. System board.
- Quick Links:
- Beep Symptoms
Hide quick links:
Advertisement
Table of Contents
