Cisco CATALYST 6000 Installation And Configuration Note page 22
Catalyst 6000 series content switching module
Hide thumbs
Also See for CATALYST 6000:
- Manual (52 pages) ,
- Product bulletin (4 pages) ,
- Installation note (18 pages)
Table of Contents
Advertisement
Configuring the Content Switching Module
Figure 8
Client-side VLAN IP address
*
NAS
Gateway
See
Figure 8
*Any router configured as a client-side gateway or a next hop router for servers more than one hop
Note
away must have ICMP redirects disabled. The CSM does not perform a Layer 3 lookup to forward
traffic; the CSM cannot act upon ICMP redirects.
Note
** HSRP provides automatic router backup using an active standby router that allows active and
standby routers in an HSRP group to exchange messages and respond to topology changes by
selecting a new active router dynamically. Because traffic can come from both the virtual and
physical MAC addresses of the gateway, the CSM uses two entries per virtual IP gateway configured.
You can configure only seven client gateways on the CSM. An HSRP group is assigned one client
gateway for the virtual IP address when it is configured. (See the
page
43.)
Catalyst 6000 Family Content Switching Module Installation and Configuration Note
22
Configuring VLANs
Catalyst 6500
HSRP
**
PDA
handset
for the following notes:
Content
Services
Server-side VLAN
Gateway
Content
provider
"Configuring HSRP" section on
78-11631-02 Rev. A0
Advertisement
Chapters
Table of Contents
