Verifying Your Installation; Optional Installation Steps - Cisco 1712 Hardware Installation Manual
Security access routers
Hide thumbs
Also See for 1712:
- Quick start manual (13 pages) ,
- Datasheet (8 pages) ,
- Hardware installation manual (216 pages)
Table of Contents
Advertisement
Verifying Your Installation
Verifying Your Installation
Optional Installation Steps
Cisco 1711 and Cisco 1712 Security Access Routers Hardware Installation Guide
2-10
You can verify that you have correctly installed the router by checking the
following LEDs:
PWR (front panel)—On when power is being supplied to the router.
•
OK (front panel)—On when the router software is loaded and functional.
•
Blinking means that the router is performing a power-on self-test (POST).
WIC0/WIC1 OK (back panel)—On when a WIC is correctly installed in the
•
corresponding WIC slot.
ETH ACT (front panel)—Blinking when there is network traffic on the local
•
10/100 Ethernet LAN.
WIC0ACT or WIC1 ACT (front panel)—See
•
LINK (back panel)—On when the router is correctly connected to the local
•
Ethernet LAN through the 10/100 ETHERNET port.
MOD OK (back panel)—On when the VPN hardware encryption module is
•
installed and recognized by IOS.
This section describes some installation steps that you might or might not use,
depending on your site and on how you are configuring the router. This section
describes the following procedures:
Connecting a PC to the Router's Console Port
•
•
Connecting a Modem on the AUX Port
Wall-Mounting
•
Stacking the Router
•
Unstacking the Router
•
Chapter 2
Installation
Table
1-3.
OL-4050-02
Advertisement
Table of Contents
