▀ R-eWAG Administration
monitor protocol
For R-eWAG use the following filters:
41 - IPSG RADIUS Signal: Must be used to view the RADIUS accounting messages on the control path for
IPSG session management.
24 - GTPC
26 - GTPU
Monitor Subscriber
The system's protocol monitor can be used to display information for a specific subscriber session that is currently
being processed. Depending on the number of protocols monitored, and the number of sessions in progress, a significant
amount of data is generated. It is highly recommended that logging be enabled on your terminal client in order to
capture all of the information that is generated.
To view monitor subscriber based logging information, in the Exec Mode use the following command:
monitor subscriber
The following filters are available for monitor subscriber based logging in R-eWAG.
By MSID/IMSI
By IP Address
By MSISDN
Next-IPSG Call
By Username
Gathering R-eWAG-related Statistics and Information
Table 4. R-eWAG Statistics and Information
eWAG-related statistics or information
To view concise R-eWAG service-level information.
To view detailed R-eWAG service-level information.
To view R-eWAG service-level statistics, including session and
RADIUS message-level statistics.
To view R-eWAG session counter information.
To view R-eWAG subscriber information.
To view detailed R-eWAG session information, for all sessions.
To view detailed subscriber information, for all subscribers.
To view session progress information for in-progress calls.
To view IPSG Manager related information.
▄ Cisco ASR 5000 Enhanced Wireless Access Gateway Administration Guide
64
RADIUS-based Enhanced Wireless Access Gateway Configuration
CLI command to use
show ipsg service all
show ipsg service all verbose
show ipsg statistic
show ipsg sessions counters
show subscribers ipsg-only
show ipsg sessions full all
show subscribers full all
show session progress
show session subsystem facility ipsgmgr