Flange Back Adjustment (Using Minipattern Box); Flange Back Adjustment - Sony CCD-TR317 Service Manual
Handycam & handycam vision video camera recorder video 8 / hi8 xr
Hide thumbs
Also See for CCD-TR317:
- Operating instructions manual (68 pages) ,
- Service manual (6 pages)
Table of Contents
Advertisement
2. Flange Back Adjustment
(Using Minipattern Box)
The inner focus lens flange back adjustment is carried out
automatically. In whichever case, the focus will be deviated during
auto focusing/manual focusing.
Subject
Siemens star chart with ND filter for
the minipattern box (Note1)
Measurement Point
Check operation on TV monitor
Measuring Instrument
Adjustment Page
F
Adjustment Address
4E to 5D
Note1: Dark Siemens star chart.
Note2: Make the lens horizontal and perform this adjustment.
Switch setting:
1)
NIGHT SHOT .................................................................. OFF
2)
DIGITAL ZOOM (Menu display) ................................... OFF
3)
STEADY SHOT (Menu display) ..................................... OFF
4)
VIDEO LIGHT ................................................................ OFF
Preparations before adjustments:
The minipattern box is installed as shown in the following figure.
Note: The attachment lenses are not used.
Specified voltage: The specified voltage varies according to the
minipattern box, so adjust the power supply
output voltage to the specified voltage written
on the sheet which is supplied with the
minipattern box.
Minipattern box
Regulated power supply
Output voltage : Specified voltage ±0.01Vdc
Output current : more than 3.5A
Red (+)
Black (–)
Yellow (SENS +)
White (SENS –)
Need not connected
Black (GND)
Fig. 5-1-7.
Below 3 cm
Camcorder
Camera
table
5-20
Adjusting method:
1)
Install the minipattern box so that the distance between it and
the front of the lens of the camcorder is less than 3cm.
2)
Make the height of the minipattern box and the camcorder equal.
3)
Check that the output voltage of the regulated power supply is
the specified voltage.
4)
Check that at both the zoom lens TELE end and WIDE end,
the center of the Siemens star chart and center of the exposure
screen coincide.
5)
Select page: 0, address: 01, and set data: 01.
6)
Check that the data of page: F, address: 4E to 5D is the initial
value (See table below).
Address
Data
4E
28
4F
07
50
3A
51
4A
52
12
53
0B
54
54
55
00
7)
Select page: 6, address: 02, and check that the data is "00".
8)
Select page: 6, address: 01, set data: 13, and press the PAUSE
button of the adjustment remote commander.
9)
Select page: 6, address: 01, set data: 27, and press the PAUSE
button.
(The adjustment data will be automatically input to page: F,
addresses: 4E to 5D.)
10) Select page: 6, address: 02, and check that the data is "01".
Processing after Completing Adjustments:
1)
Select page: 0, address: 01, and set data: 00.
2)
Turn off the power and turn on again.
3)
Perform "Flange Back Check".
Address
Data
56
19
57
00
58
37
59
00
5A
00
5B
04
5C
00
5D
00
Hide quick links:
Advertisement
Table of Contents
