Reinitializing The Snapshots; Control From The Pve-500 - Sony DFS-700 Service Manual
Dme switcher, digital/analog input board, analog composite input board, digital multi effects board, 3d video mapping effects board
Hide thumbs
Also See for DFS-700:
- Operating instructions manual (212 pages) ,
- Specifications (8 pages)
Table of Contents
Advertisement
Snapshots
Reinitializing the Snapshots
By reinitializing the snapshot registers, you can return them all to their
factory defaults.
Use the following procedure.
1
Press the SET UP button.
The setup menu appears.
2
Press the PAGE button to display page 6/8.
3
Press the F2(SNAP) button, to set it to "ON".
4
Press the F5(EXEC) button.
A confirmation message appears.
5
To go ahead and reinitialize all snapshots, press F3(OK); to cancel
press F5(CANCEL).
When you press F3, all of the snapshots are returned to their factory
defaults.
4-24
Chapter 4 Advanced Operations
Control From Editing
Control Units
Control From the PVE-500
You can combine the DFS-700/700P with the PVE-500 Editing Control
Unit to carry out A/B roll editing using two players and one recorder.
The PVE-500 controls the DFS-700/700P using PVE-500 control signals
and GPI signals.
Note
For details of preread editing, see the section "Preread Editing" (page 5-
14).
Control using PVE-500 control signals
You can control the following DFS-700/700P functions using 9-pin serial
control signals from the PVE-500. Input these signals to the EDITOR
connector on the rear panel of the DFS-700/700P.
• Selecting the background image (FROM source) and foreground image
(TO source)
• Setting the transition duration
• Executing auto transitions
• Automatic snapshot (when you save editing data on the PVE-500, DFS-
700/700P snapshots are saved and recalled automatically.)
For more information about controlling these functions, refer to the PVE-500
Operating Instructions.
Downstream key control using GPI signals
You can use GPI pulse signals from the PVE-500 to turn the DFS-700/
700P downstream key function on or off on the falling edge of a pulse.
Input the GPI signals to the T2 connector on the DFS-700/700P.
For details of GPI signal timing, see page 5-13.
Chapter
5-1
Chapter 5 Control From Editing Control Units
- Quick Links:
- Manual Structure
Hide quick links:
Advertisement
Table of Contents
